User manual LG LHS-C2330W

[. . . ] Instead, they are requested to directly contact a designated service center or the outlet at which the product was purchased. Never spill any kind of liquid into the unit. Should this happen, unplug or main switch off the unit and contact an authorized service center. Do not insert anything between the air outlet blades because the inner fan may be damaged and could cause injury. [. . . ] You can also set the fan speed. Remote Control Control Panel 1 If necessary, press the (On/Off) button. The operating mode indicator (COOL, FAN or HEAT) on Result: the unit comes on. The air conditioner starts up in the mode selected when the unit was last used. air Theunit conditioner is fitted with a protection mechanism to prevent the from being damaged when it is started immediately after being: Plugged in Stopped It will start up automatically after about three minutes. 2 If the HEAT indicator is not lit up on the unit: Press the button on the remote control or Press the MODE button on the unit one or more times until the HEAT indicator lights up The unit beeps each time you press MODE. Result: The air conditioner starts up in Heat mode. 3 You can change modes at any time. To adjust the temperature, press the or button on the remote control one or more times until the required temperature is displayed. To adjust the temperature, press the or button on the unit one or more times until the required temperature is displayed. Possible temperatures are between 16°C and 30°C inclusive. Each time you press the temperature buttons: Result: ­ The temperature is adjusted by 1°C and displayed on the control panel ­ The unit beeps The air conditioner starts heating if the room temperature is lower than the selected temperature. 4 To set the fan speed to. . . Press the button on the remote control. or Press the on the unit until the indicator lights up Press the button on the remote control. or Press the on the unit until the indicator lights up Press the button on the remote control. Press the or Press the Result: button on the remote control button on the unit until the SLEEP indicator lights up. Each time you press a button, the unit beeps. The "SLEEP" passes through the control panel for about " will be displayed. 15 seconds and the " The remaining time is displayed and decreased by 1 hour automatically to indicate the remaining time. The air conditioner will be controlled as illustrations below. Cooling When the temperature has been increased by 1°C (after 1 hour), it is maintained for 7 hours. Set TEMP. Start time 1hr Stop time 8hr Heating The temperature is decreased by 1°C after 1 hour. When it has been decreased by 2°C (after 2 hour), the temperature is maintained for 6 hours. To Cancel the Sleep Timer To cancel the timer, press: on the remote control. The SLEEP indicator is no longer displayed. The air conditioner operates in the mode selected last. E-14 Operating Recommendations ENGLISH Here are a few recommendations that you should follow when using your air conditioner. Topic Heating performances Recommendation The heat pump inside the air conditioner absorbs heat from outside air and brings it indoors. If the temperature of the outside air drops, the air conditioner will heat less. If you find that the room is not warm enough, use an additional heating appliance. [. . . ] Model EA Power Supply 220-240V~, 50Hz E-18 Installation Before installation, be sure to check the installation area or the air conditioner, and drain hose. Checkpoints prior to installation 1 Check the cabinet and front grille of the unit for any harmful defects such as scratches. - Refer to the specifications on the label attached to the unit. Installation Conditions 1 As the unit is heavy, the wall or window of the installation area should have sufficient strength and durability for operation of the air conditioner, and for prevention of any vibration or noise. [. . . ]