User manual LG LHS-C6230T

[. . . ] Never spill any kind of liquid into the unit. Should this happen, unplug or main switch off the unit and contact an authorized service center. Do not insert anything between the air outlet blades because the inner fan may be damaged and could cause injury. Do not place any obstacles in front of the unit. [. . . ] Possible temperatures are between 8°C and 30°C inclusive. Result: Each time you press the temperaure buttons. - The temperature is adjusted by °C and displayed on the control panel - The unit beeps The air conditioner starts cooling if the room temperature is higher than the selected temperature. Press the button on the remote control. or Press the on the unit until the indicator lights up Press the button on the remote control. or Press the on the unit until the indicator lights up Press the button on the remote control. or Press the on the unit until the indicator lights up Each time you press a button, the unit beeps. E-9 4 To set the fan speed to. . . High Med Low Result: 5 To control the direction of the air flow, refer to page . DB98-22419A-1. indd 9 2007-1-10 20:20:25 Airing Your Room If the atmosphere in your room is stale, you can air it using the Fan feature and if necessary, evacuate the stale air outside. If you wish to evacuate stale air outside, push the ventilation lever on the front of the unit to the right and the open position ( ). Result: The air inside the room circulates and stale air is evacuated outside. Otherwise, push the ventilation lever to the left and the closed position ( Result: ). The air simply circulates inside the room. Remote Control Control Panel If necessary, press the Result: (On/Off) button. The operating mode indicator (COOL, FAN or HEAT) on the unit comes on. The air conditioner starts up in the mode selected when the unit was last used. The remaining time is displayed and decreased by hour automatically to indicate the remaining time. The air conditioner will be controlled as illustration below. Cooling When the temperature has been increased by °C(after hour), it is maintained for 7 hours. Set TEMP. 1hr 8hr Start time Stop time Heating The temperature is decreased by °C after hour. When it has been decreased by °C (after hour), the temperature is maintained for 6 hours. To Cancel the Sleep Timer To cancel the timer, press: on the remote control. The SLEEP indicator is no longer displyed. The air conditioner operates in the mode selected last. E-4 DB98-22419A-1. indd 14 2007-1-10 20:20:33 Operating Recommendations Here air a few recommendations that you should follow when using your air conditioner. Topic Common Recommendation Airconditioner should be used only in the single closed room. Effective airconditioner operation can be guarantee if all windows and doors in the room are closed. The heat pump inside the air conditioner absorbs heat from outside air and brings it indoors. If the temperature of the outside air drops, the air conditioner will heat less. If you find that the room is not warm enough, use an additional heating appliance. The air conditioner circulates warm air to heat your room;as a result, some time will be required after starting the air conditioner to warm the entire room. If necessarty, set the air conditioner going a short time before you wish to use the room. [. . . ] When operating the air conditioner in closed areas such as inner building with cooling operation, and result in trouble with the unit. The appliance must be fixed well by screw or similar method. 75mm Awning 300mm min. 500mm 500mm 170 mm 500mm Fence, wall or other obstacle Approx. 3 750mm 150mm min. If the wall is greater than 50mm thick, cut the wall back on a 45 angle if possible. Outdoor side 45 Indoor side 00mm or more 45 E-9 DB98-22419A-1. indd 19 2007-1-10 20:20:37 Method Of Installation (cont. ) In some region, drain tube and drain pan may not be supplied. Plesae contact the sales agent. Rear Installation of the Drain Tube Fix the drain tube as shown in the figure. Rubber cap Gasket Drain Tube Screws(EA) Installation of the Drain Pan The procedure for installing the drain pan should be determined by the condition of the installing area. [. . . ]