User manual LG LM-1030

[. . . ] ⷠIf you move to another area, repeat this procedure to store the stations for your new area. Before unplugging the DAB antenna, make sure the system is turned off to preserve your own DAB settings. ⷠThis tuner does not support data services. This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. [. . . ] Hold down / (rewind/ fast forward) during playback, and release it at the desired point. Press / on the remote repeatedly to set the hour, and then press ENTER on the remote. use the same procedure to set the minutes. The clock settings are lost when you disconnect the power cord or if a power failure occurs. * Be sure to press (stop/eject) on the unit after the tape has been wound or rewound to the end. Do not turn off the system during playback or recording. When you turn on the system for the first time after you purchase the system, DAB Automatic Scan starts automatically and creates a list of available services. If you want to run the DAB Automatic Scan again, perform the procedure below. Depending on the DAB services available in your area, scanning may take a few minutes. Press PLAY MODE on the remote repeatedly while the player is stopped. You can select normal play (" " for all MP3 files in the folder on the disc), shuffle play ("SHUF" or " SHUF*"), or program play ("PGM"). 1 Make sure the power cord and speaker cords are 2 Find your problem in the checklist below, and take While the player is stopped. With the side you want to record facing forward. When recording a folder from an MP3 disc, press PLAY MODE on the remote repeatedly to select " , " and then press +/­ on the remote repeatedly to select the desired folder. To record only your favorite CD tracks or MP3 files in your desired order, perform steps 2 to 5 of "Creating your own CD program. Repeatedly until the desired track number appears. When programing MP3 files, press +/­ repeatedly to select the desired folder, and then select the desired file. Selected track or file number Immediately unplug the power cord, and check the following item. ⷠIf your system has a voltage selector, is the voltage selector set to the correct voltage?After the STANDBY indicator stops flashing, reconnect the power cord, and turn on the system. Do not place the system in an inclined position or in locations that are extremely hot, cold, dusty, dirty, or humid or lacking adequate ventilation, or subject to vibration, direct sunlight or a bright light. ⷠBe careful when placing the unit or speakers on surfaces that have been specially treated (for example, with wax, oil, polish) as staining or discoloration of the surface may result. [. . . ] If the tape deck is still playing or recording at the set time, the system turns off after the tape deck stops. Clean this system with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as thinner, benzine, or alcohol. Halogenated flame retardants are not used in the certain printed wiring boards. [. . . ]