User manual LG LMNH186BTG0.ANWADXB

[. . . ] Instead, they are requested to directly contact a designated service center or the outlet at which the product was purchased. x Never spill any kind of liquid into the unit. Should this happen, unplug or main switch off the unit and contact an authorized service center. x Do not insert anything between the air outlet blades because the inner fan may be damaged and could cause injury. [. . . ] x If the room temperature reaches the set temperature, the air conditioner stops heating, but the fan is still operating. button one or more times ) 4 Select the fan speed by pressing the until the required setting is displayed: Automatic (rotated : Low Medium High Result: x Each time you press the button, the indoor unit beeps. x For the first three to five minutes, the fan operates very slowly until the air has been sufficiently warmed. Once the correct temperature has been reached, the fan is automatically set to the required speed. 5 6 To select the Digital Flow, refer to page 16. To control the direction of the air flow, refer to page 17. E-11 Removing Excess Humidity If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much. In DRY mode, the quantity of air and the direction of the air flow is adjusted automatically. 1 If necessary, press the Result: (On/Off) button. x The operation indicator on the indoor unit lights up. x The air conditioner starts up in the mode selected when the unit was last used. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Switched on x Stopped It will start up normally after three minutes. IMPORTANT 2 If the is not displayed at the top of the remote control, press the button on the remote control one or more times until it appears. Result: Note x The indoor unit beeps each time you press the x The air conditioner runs in DRY mode. button. 3 To adjust the temperature, press the button one or more times until the required temperature is displayed. Result: The blades move left and right, around the base position set. button again. 3 To stop the blades moving left and right, press the E-17 Setting the On Timer The On Timer enables you to switch on the air conditioner automatically after a given period of time. You can set the period of time from 30 minutes to 24 hours. You can select the On Timer only when the air conditioner is off. 1 To set the operating time, press the 24 hours inclusive. button one or more times until the required time is displayed. Possible time is between 30 minutes and 2 Press the Result: (Set/Cancel) button to complete the setting. x Blinking of the timer indicator stops. x The selected mode and the temperature on the display disappear after 10 seconds. x The air conditioner will switch on automatically when the counter displayed on the remote control reaches the set time and disappears the On timer setting. 3 To select an operating mode in advance, press the button until the desired mode is displayed at the top of the remote control. Result: x The air conditioner will run in the selected mode when it is turned on. To Cancel the On Timer Press the (Set/Cancel) button. E-18 Setting the Off Timer The Off Timer enables you to switch off the air conditioner automatically after a given period of time. [. . . ] A water leak or some other malfunction may occur if the heat exchanger freezes. Water may condense on and drip from the surface of the indoor unit if it is used for long periods. Outdoor Temperature 0°C to 24°C approx. Indoor Humidity 80% or less - If the outdoor temperature is as low as 0°C, the heating capacity drops up to 70~80% depending on the operating condition. [. . . ]