User manual LG LMV-1620DB

[. . . ] The user could lose the authority to operate this equipment if an unauthorized change or modification is made. REGULATORY INFORMATION: FCC Part 15 This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. [. . . ] Remove the lens mount cap from the camera. era opening and turn the lens slowly to install it. 2-2 2-1 2. Install the auto-iris lens. CS mount type lens Carefully align the lens mount with the camera opening, then turn the lens slowly to install it. C mount type lens To allow for flange- back adjustment, install the C-mount adaptor (option) on the lens mount, then carefully align the lens mount with the cam3. Connect the lens plug to the lens iris output connector (LENS) on the side of the camera. When using lenses from other makers, the plug shape may not correspond to the terminal on the camera. In such a case, remove the original plug and using a soldering iron, connect a lens iris plug according to the diagram. (Refer to next page. ) 2-2 2-1 12 Connections lens iris output connector Pin layout for the lens iris output connector. Rewire the lens iris plug 1. Cut off the plug of the lens cable, cut off approximately 8 mm of the insulation, and then strip approximately 2 mm of the ends of the cable sheaths. No. A B C D DC type lenses Damping Damping + Drive + Drive 2. Solder the ends of the cable wires to the ends of the pins, and then attach the cover of the lens iris plug. 13 Connections Flange-back Adjustment The adjustment is required only when a lens without focus-adjusting mechanism is mounted, or when a lens with adjusting mechanism is mounted and focus that is more accurate is needed. > SHUTTER: Select the desired shutter speed for camera exposure. You can change the shutter speed to higher speed to capture fast-moving subjects, though the image becomes darker. > AGC: If the images are too dark, change the maximum [AGC] value to make the images bright. White Balance Setting Select the method by which the camera shifts its output colors to compensate for the color of a light source. · ATW (Auto-Tracing White Balance): The color tem¬perature range for the proper white balance is approximately 1 800 K to 10 500 K. Proper white balance may not be obtained under the following conditions: > The color temperature is out of the 1 800 K to 10 500 K range. > the scene contains mostly high color temperature objects, such as a blue sky or sunset. 24 Menu Operation > > When the scene is dim. SPEED: Use [LEFT] or [RIGHT] to set the ATW pull-in speed. If you select high value, ATW pull-in speed becomes higher. > DELAY CNT: You can adjust the time-based hysteresis of ATW. > ATW FRAME: can set the AFW frame value. If you set frame value high, the tracking will be faster. > ENVIRONMENT: Use [LEFT] or [RIGHT] button to select a function. [. . . ] Use [LEFT] or [RIGHT] button to select the Area Selection (1 to 4) on the [AREA SEL]. · · · TOP: Moves top position on the screen. BOTTOM: Moves bottom position on the screen. LEFT: Moves left position on the screen. 29 Menu Operation 4. [. . . ]