User manual LG LN-0880AC

[. . . ] Following the implementation by member states, private households within the EU states may return their used electrical and electronic equipment to designated collection facilities free of charge*. In some countries* your local retailer may also take back your old product free of charge if you purchase a similar new one. *) Please contact your local authority for further details. Attention: Your product is marked with this symbol. It means that used electrical and electronic products should not be mixed with general household waste. There is a separate collection system for these products. If your used electrical or electronic equipment has batteries or accumulators, please dispose of these separately beforehand according to local requirements. [. . . ] During operation of the air conditioner, the filters remove dust and tobacco smoke from the air and discharges clean air. 1 Take out the air filters. 1 Open the open panel. 1 2 3 2 Push the air filters up slightly to unlock them. 3 Pull the air filters down to remove them. Filter stopper deodorant dust collection 2 Set thethe filter stoppers locatedfilter under on the air filter. Deodorant dust collection filter Air filter air 3 Reinstall the the filters in the origi1 Reinstall air filters nal positions. 3 Push the arrow-marked of the panel firmly to lock it in place. 3 2 1 Precautions The filters are sealed in a plastic bag to keep their dust collection effect. Do not open the bag until using the filters. (Otherwise the filters life may get shorter. ) Do not expose the filters to direct sunlight. (Otherwise they may deteriorate. ) 5 USING THE REMOTE CONTROL LOADING BATTERIES Use two size-AAA (R03) batteries. 1 Remove cover. the remote control Remote control cover batteries in 2 Insert making surethe compartment, the and -- polarities are correctly aligned. The display indicates "AM 6:00" when batteries are properly installed. the cover. + - 3 Reinstall - + NOTES: The battery life is approximately one year in normal use. When you replace the batteries, always change both batteries, and make sure they are the same type. If the remote control does not operate properly after replacing the batteries, take out the batteries and reinstall them again after 30 seconds. Approximately the same numbers of positive and negative ions released into the air will reduce some airborne mold. 1 During operation, press the PLASMACLUSTER button. The remote control will display " " The blue PLASMACLUSTER lamp on the unit will light up. TO CANCEL 1 DISPLAY Press the PLASMACLUSTER button again. The PLASMACLUSTER lamp on the unit will turn off. NOTES: Use of the PLASMACLUSTER operation will be memorized, and it will be activated the next time you turn on the air conditioner. To turn off the PLASMACLUSTER lamp, press the DISPLAY button. When the PLASMACLUSTER button is pressed while the unit is not operating, the PLASMACLUSTER operation will be performed without accompanying air conditioning mode (eg, HEATING or COOLING). The mode symbol of the remote control will go off and the fan speed can not be set AUTO. 10C OPERATION Heating operation with 10C set temperature will be performed. AM 2 DISPLAY MODE 1h 1 Press the MODE button and select HEAT mode. 2 Press the ON/OFF button to start HEAT operation. 3 Pressremote control will display 10C . The TO CANCEL Press the 10C button again. 10C operation will also be cancelled when the operation mode is changed, or when the unit is turned off. CLEAN FAN SWING 1 3 NOTE: 10C operation will not be available with heating operation automatically selected by AUTO mode. 12 SELF CLEAN OPERATION SELF CLEAN operation will provide effect to reduce the growth mold fungus, and to dry inside of the air conditioner unit with Plasmacluster ions. This operation is accompanied by FAN or HEAT mode. Utilize the operation at seasonal change over terms. Mold fungus already grown can not be eliminated by this operation. 1 Press the SELF CLEAN button when the unit is not operating. The remote control displays " ". [. . . ] 2 Make sure that nothing obstructs the air inlet or outlet. rack 3 Check the outdoor mountingmake periodically for wear and to sure it is firmly in place. CHANGING THE DEODORANT DUST COLLECTION FILTER The filter should be changed every 3 ~ 6 months Filter stopper 1 REMOVE THE AIR FILTER 2 CHANGE THE DEODORANT COLLECTION FILTER DUST 1 Take off the old deodorant dust collection filter from the air filter. 2 Set the new deodorant dust collection filter, under the filter stoppers located on the air filter. 3 REINSTALL THE AIR FILTER NOTE: The dirty deodorant dust collection filter is not washable for reuse. The new filter is available at your nearest dealer. Replacement filter: Type AZ-F920FN Disposal of Filters Please dispose of replaced filters according to the local disposal laws and regulations. DEODORANT DUST COLLECTION Filter materials: Filter: Polypropylene Frame: Polyester 17 ADDITIONAL NOTES ON OPERATION OPERATING TEMPERATURE RANGE INDOOR TEMP. [. . . ]