User manual LG LRSPC2331W

[. . . ] *) Please contact your local authority for further details. It means that used electrical and electronic products should not be mixed with general household waste. There is a separate collection system for these products. If your used electrical or electronic equipment has batteries or accumulators, please dispose of these separately beforehand according to local requirements. [. . . ] The outside air temperature therefore greatly affects the heating efficiency. ⷠIf the heating efficiency is reduced due to low outside temperatures, use an additional heater. ⷠIt takes time to warm up and heat the entire room because of the forced air circulation system. Below are some simple ways to save energy when you use your air conditioner. Setting the thermostat 1°C higher than the desired temperature in the COOL mode and 2°C lower in the HEAT mode will save approximately 10 percent in power consumption. ⷠSetting the temperature lower than necessary during cooling operation will result in increased power consumption. Blocking direct sunlight during cooling operation will reduce power consumption. ⷠClose the windows and doors during cooling and heating operations. The indoor unit still consumes a small amount of power when it is not operating. NOTE: Actual units might vary slightly from those shown above. H TIMER OFF INDICATOR Indicates the preset time for off timer or onehour off timer. This air conditioner is a multi-type, and multiple indoor units are connected to one outdoor unit. When the setting mode differs among indoor unit(s), the indoor unit(s) operated later may not work. ⷠWhen the indoor unit(s) is/are operating in HEAT mode, the remaining unit(s) can not operate in COOL or DRY mode. ⷠWhen the indoor unit(s) is/are operating in COOL or DRY mode, the remaining unit(s) can not operate in HEAT mode. When the mode of the indoor unit(s) later operated is/are different from those which is/are in operation, after a few seconds, a long BEEP will be emitted and the OPERATION lamp and TIMER lamp will blink alternately. This shows that the later operated unit(s) is/are not working. In such case, change the remote control's mode and send the same mode signal which the other indoor unit(s) is/ are operating in. In the AUTO mode, the temperature setting and mode are automatically selected according to the room temperature and outdoor temperature when the unit is turned on. During operation, if the outdoor temperature changes, the temperature settings will automatically slide as shown in the chart. ⷠMode of the unit operated first will have priority over unit(s) without reference to the chart. The adjusted position will be memorized and will be automatically set to the same position when operated the next time. [. . . ] Approximately the same numbers of positive and negative ions released into the air will reduce some airborne mold. The blue PLASMACLUSTER lamp on the unit will light up. The PLASMACLUSTER lamp on the unit will turn off. In the COOL and DRY operation, water vapour can sometimes be seen at the air outlet due to the difference between the room air temperature and the air discharged by the unit. [. . . ]