User manual LG LRTG2011W

[. . . ] x When moving, consult authorized service personnel for disconnection and installation of the unit. x Do not become over-exposed to cold air by staying in the direct path of the airflow of the air conditioner for extended periods of time. x Do not insert fingers or objects into the outlet port or intake grilles. x Do not start and stop air conditioner operation by disconnecting the power supply cord and so on. [. . . ] To set to the required position, press the Swing button again when the blades are in the required position. E-17 Setting the On Timer The On Timer enables you to switch on the air conditioner automatically after a given period of time. You can set the period of time from 30 minutes to 24 hours. 1 To set the operating time, press the On Timer button one or more times until the required time is displayed. Possible time is between 0. 5 hour and 24 hour inclusive. Result: x Each time you press On Timer button: - The time is adjusted by 0. 5 hour to 5 hours, by 1 hour from 6 hours to 24 hours. 2 Press the (Set/Cancel) button to complete the setting. Result: x The remaining time is displayed. x Blinking of the timer indicator stops. x The selected mode and the temperature disappear on the display after 5 seconds. x The air conditioner will switch on automatically when the counter displayed on the remote controller reaches the setting time as disappearing the On timer setting. Note You can see or change the setting mode and/or the temperature by pressing the Mode button or the Temperature buttons after setting the On timer. To Cancel the On Timer 1 To cancel the On Timer, press the On Timer button one or more times until the timer setting disappears. 2 Press the (Set/Cancel) button. Note If you want to turn on the air conditioner before the timer reaches the setting time, press the (ON/OFF) button. E-18 Setting the Off Timer ENGLISH The Off Timer enables you to switch off the air conditioner automatically after a given period of time. You can set the period of time from 30 minutes to 24 hours. 1 To set the operating time, press the Off Timer button one or more times until the required time is displayed. Possible time is between 0. 5 hour and 24 hour inclusive. x The air conditioner starts cooling, provided that the room x temperature is higher than the selected temperature ; x the fan will, however, operate. 4 Select the fan speed by pressing the Fan button one or more times until the intended value is displayed : Automatic(rotated : Low Medium High ) 5 To control the direction of the air flow, refer to page 25. E-22 Heating Your Room (Except Cooling Only Models) ENGLISH You can select the HEAT mode only in heat pump models. You must select the HEAT mode if you wish to adjust the : x Heating temperature x Fan speed when heating 1 If necessary, press Result: (ON/OFF) button. x The On/Off indicator on the wired remote controller comes on. x The air conditioner runs in the mode selected when x the unit was last used. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Plugged in x Stopped lt will start up normally after three minutes. IMPORTANT 2 To select the HEAT mode, press the Mode button until top of the wired remote controller. Result: Note x The air conditioner runs in HEAT mode. You can change modes at any time. is displayed at the 3 To adjust the temperature, press the Temperature buttons one or more times until the required temperature is displayed. Possible temperatures are between 61OF and 86OF inclusive. Result: x Each time you press Temperature buttons: - The temperature is adjusted by 1OF. x The air conditioner starts heating, provided that the room x temperature is lower than the selected temperature ; x the fan will, however, operate. 4 Select the fan speed by pressing the Fan button one or more times until the intended value is displayed : Automatic(rotated : Low Medium High ) 5 To control the direction of the air flow, refer to page 25. E-23 Removing Excess Humidity If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much. 1 If necessary, press Result: (ON/OFF) button. x The On/Off indicator on the wired remote controller comes on. x The air conditioner runs in the mode selected when x the unit was last used. IMPORTANT The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Plugged in x Stopped It will start up normally after three minutes. is displayed at 2 To select the DRY mode, press the Mode button until the top of the wired remote controller. Result: Note x The air conditioner runs in DRY mode. [. . . ] When you have finished, insert the filter into the front grille. Clean the unit with a vacuum cleaner or a brush once a month. Reinstall the front grille and the safety clips. Note You can use all 4 points of the indoor unit for installing the front grille and the safety clips depending on your requirement. [. . . ]