User manual LG LRTX18321BK

[. . . ] Then, connect the signal input cable. A When connecting with the D-Sub signal input cable. (RGB) RGB IN Rear side of the product. PC B When connecting with the DVI signal input cable. DVI IN Rear side of the product. PC Connect the power cord. Rear side of the product. 3 Connecting to External Devices 1 Turn on power by pressing the power button on the product. SOURCE Zoom Power button 2 Turn on the PC. To change input source Press the SOURCE button on the remote control to select the input signal. Or, press the SOURCE button on the bottom of the product. DVI signal D-Sub signal Note · How to connect to two computers. Connect the signal cables (DVI and D-Sub) to each computer. [. . . ] 4) Press the button and then use button to set the minutes(00~59). The off time automatically switches the set to standby at the pre-set time. 1) Press the MENU button and then use 2) Press the button and then use button to select Off Time or On Time. 3) Press the button and then use button to set the hour(00~23). 4) Press the button and then use button to set the minutes(00~59). 5) Press the MENU button. On/ Off Time Function To set automatic On/Off. On : Automatically turn the product On/Off at preset times. Off : Disable the On/Off Time function. Note In the event of power interruption (disconnection or power failure), the clock must be reset. Once the on or off time is set, these functions operate daily at the preset time. Off time function overrides On time function if they are set to the same time. When On time is operated, input screen is turned on as it was turned off. 14 User Menus Adjusting OSD image OSD OSD Set ID H-Position V-Position On-Screen Time Halftone Factory Reset 1 3 10 10 63 Move Select MENU Exit Set ID You can assign a unique Set ID NO (name assignment) to each product when several products are connected for display. If the frequency is out of range, set to the recommended resolution in the Control Panel ­ Display ­ Setting menu. · D-Sub analog signal ­ Press the "AUTO" button in the remote control to automatically select an optimal screen status that fits into the current mode. If adjustment is not satisfactory, use the Clock OSD menu. · D-Sub analog signal ­ Press the "AUTO" button in the remote control to automatically select an optimal screen status that fits into the current mode. If adjustment is not satisfactory, use the Phase OSD menu. · The proper input signal is not connected to the signal port. Connect the signal cable that matches with the source input signal. G Do thin lines appear on the background screen? G Horizontal noise appears or the characters look blurred. G The screen is displayed abnormally. After-image appears on the product. G After-image appears when the product is turned off. · If you use a fixed image for a long time, the pixels may be damaged quickly. Use the screen-saver function. 17 Troubleshooting Screen color is abnormal. G Screen has poor color resolution (16 colors). · Set the number of colors to more than 24 bits (true color) Select Control Panel ­ Display ­ Settings ­ Color Table menu in Windows. · Check the connection status of the signal cable. [. . . ] * [Set ID]: Set up the Set ID number of product. by setting '0', server can control all products. * In case of operating with more than 2 sets using set ID as '0' at the same time, it should not be checked the ack message. Because all sets will send the ack message, so it's impossible the check the whole ack messages. [. . . ]