User manual LG LS-D1864CS

[. . . ] These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. · A suitable conduit entries, knock-outs or glands shall be provided in the cable entries of this product in the end user. This lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] Note: The RTSP port number should not be same with the web port number. TTL: This option indicates the Time-To-Live of multicast packets. The default setting is 7, and the allowed TTL range is 1-255. RTP stream RTP (Real-time Transport Protocol) is an internet protocol that allows programs to manage the real-time transmission of multimedia data, via unicast or multicast. > TTL > ARP Ping > Enable ARP Ping to configure IP address: Check to enable ARP ping. · Save: Click this button to confirm the settings. 37 Operation and settings Master / Slave > RTP unicast: When enabled the transmission of the data to the specified equipment happens on a network specifying a single address. > RTP multicast: When enabled it reduces the transmission load on the camera by making the computer of the same segment network receive the same transmission data. When multicast option is checked then select Video Port number, Audio Port number and Data port number. Video RTP port: Specify the video transmission port number used for the multicast streaming. It is initially set to 8888 and you can edit this between 1025 and 65534. Audio RTP port: Specify the audio port number used for the multicast streaming. It is initially set to 7777 and you can edit this between 1025 and 65534. Allow all: Allow all the IP address basically, but the IP addresses in the list are denied. Deny all: Deny all the IP address basically, but the IP addresses in the list are allowed. It needs at least one IP address to activate this function. Save: Click this button to confirm the settings. Add: Click this button to add the IP address. From: Enter the start IP address for the IP filtering. To: Enter the end IP address for the IP filtering. Note: If you want to deny or to allow a range of IP addresses, enter the start IP address to "From" and the end IP address to "To". You can also add an IP address by entering the IP address to "From" and "To". Repeat the steps 1-3 to add additional IP address. Remove: Click this button to delete the IP address. [. . . ] If the images appear to have white of gray stripes on it, upgrade the Video graphics driver on the client PC to the latest version. Video images may be noisy if you are using the camera in a very low light environment or the bit rate/ quality is set to very low values. Provide higher values for quality and support the surrounding environment with enough light. Audio condition · The client computer that is interacting with the camera needs to have a sound card that is functional to support speaker and microphone. [. . . ]