User manual LG LS-H126PML1

[. . . ] Removing Excess Humidity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Adjusting the Air Flow Direction Horizontally . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 7 8 9 x PROGRAMMING YOUR AIR CONDITIONER s s s s Setting the On Timer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Setting the Off Timer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Setting the Sleep Timer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Result: x The air conditioner starts up in the mode selected when the unit was last used. x The unit beeps twice. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Plugged in x Stopped It will start up normally after three minutes. 2 If the temperature is not displayed on the control panel: x Press the button on the unit one or more times until the temperature is displayed. Result: x The unit beeps each time you press the button. x The air conditioner starts up in the Cool mode. You can change modes at any time. 3 To adjust the temperature, press the or buttons on the unit one or more times until the desired temperature is displayed. The temperature can be set between 18°C and 30°C. Result: x Each time you press the or buttons: ­ The temperature is adjusted by 1°C and displayed on the control panel ­ The unit beeps x The air conditioner starts cooling, if the room temperature is higher than the selected temperature. c 4 To set the fan speed: x Press the button on the unit one or more times until the desired Fan speed(F1, F2 or F3) is displayed. Low Medium High 5 To control the direction of the air flow, refer to page 9. E-6 Airing Your Room If you want to provide air circulation without cooling, you can use the Fan mode. 1 If necessary, press the Result: (On/Off) button. x The air conditioner starts up in the mode selected when the unit was last used. x The unit beeps twice. 2 If the fan speed(F1, F2 or F3) is not displayed on the control panel: x Press the button on the unit one or more times until the fan speed (F1, F2 or F3) is displayed. Result: x The unit beeps each time you press the x The air conditioner starts up in Fan mode. The operating time can be set between 1 and 24 hours. Result: x Each time you press the button: ­ The time is adjusted by 1 hour and displayed on the control panel ­ The unit beeps x The operating time is displayed and decreases automatically to indicate the remaining time. x The air conditioner switches off automatically when the operating time reaches zero. c You can select the fan speed, temperature and Energy saving mode after setting the On timer and Off timer mode. However, when you change the mode, the On timer and Off timer mode is canceled. To Cancel the Off Timer To cancel the timer, press: x The button on the unit one or more times until "--" is displayed. or x The (On/Off) button on the unit. c E-11 Setting the Sleep Timer The Sleep Timer can be used when you are cooling your room to switch the air conditioner off automatically after 8 hours. 1 If you wish to switch the unit off at a specific time, refer to page 11. Make sure that you have selected the Cool mode. 2 Press the Result: button on the unit. x Each time you press a button, the unit beeps. x The "SLEEP" passes through the control panel for about 15 seconds and the " " will be displayed. x The remaining time is displayed and decreased by 1 hour automatically to indicate the remaining time. x The air conditioner will be controlled as illustration below. Cooling When the temperature has been increased by 1°C (after 1 hour), it is maintained for 7 hours. To Cancel the Sleep Timer To cancel the timer, press: x The button on the unit. x The SLEEP indicator is no longer displayed. [. . . ] Higher temperature Lower temperature Then. . . The automatic protection feature may be triggered and the air conditioner stopped. A water leakage or some other malfunction may happen if the heat exchanger freezes. Higher humidity levels Water may condense on and drip from the surface of the unit if it is used for long periods. E-13 Cleaning Your Air Conditioner Be sure to clean the air filter periodically to maintain the air conditioner in the best condition for a long period of time. 1 When cleaning the air conditioner, turn it off and pull out the power plug. Open the front grille by pulling the tabs on both sides of the grille. Model AW05MDYEA Power Supply 220-240V~, 50Hz Max current is measured according to IEC standard for safety and current is measured according to ISO standard for energy efficiency. This condition belongs to the above model. E-15 Installation Before installation, be sure to check the installation area or the air conditioner, and drain hose. [. . . ]