User manual LG LS-H126UMM1

[. . . ] Do Not place any obstacles in front of the outdoor unit. Do Not spray liquid of any kind into the indoor unit. Should this happen, switch off the breaker used for your air conditioner and contact your installation specialist. If the wireless remote controller will not be used for a long time, remove the batteries. [. . . ] The wireless remote controller is an optional accessory. E-20 Selecting the Automatic Operation Mode ENGLISH In the Automatic mode, the room temperature and the fan speed are controlled automatically. 1 If necessary, press Result: (ON/OFF) button. x The On/Off indicator on the unit comes on. x The air conditioner runs in the mode selected when the unit was last used. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Plugged in x Stopped lt will start up normally after three minutes. IMPORTANT 2 To select the AUTO mode, press the Mode button until at the top of the wireless remote controller. x The air conditioner runs in AUTO mode. is displayed Note You can change modes at any time. 3 To adjust the temperature, press the Temperature buttons one or more times until the required temperature is displayed. Possible temperatures are between 18OC and 30OC inclusive. Result: x Each time you press Temperature buttons: - The temperature is adjusted by 1OC. x The air conditioner takes the present temperature of the room every 30 minutes. - If the temperature is higher than the selected temperature +, the air conditioner will start cooling. - If the temperature is lower than the selected temperature -, the air conditioner will start heating. The is a preset temperature for the most comfortable environment. It can be adjusted by your installation specialist when installing the product. Note E-21 Cooling Your Room You must select the COOL mode if you wish to adjust the : x Cooling temperature x Fan speed when cooling 1 If necessary, press Result: (ON/OFF) button. x The On/Off indicator on the unit comes on. x The air conditioner starts removing the excess humidity. The quantity of air is adjusted automatically. In the dry mode, the fan speed is controlled automatically. Note 4 To control the direction of the air flow, refer to page 25. E-24 Airing Your Room ENGLISH If the atmosphere in your room is stale, you can air it using the FAN feature. 1 If necessary, press Result: (ON/OFF) button. x The On/Off indicator on the unit comes on. x The air conditioner runs in the mode selected when x the unit was last used. is displayed at 2 To select the FAN mode, press the Mode button until the top of the wired remote controller. Result: Result: Note x The indoor unit beeps. You can change modes at any time. 3 Select the fan speed by pressing the Fan button one or more times until the intended value is displayed: Low Medium High 4 To control the direction of the air flow, refer to below. Adjusting the Air Flow Direction Depending on the position of the indoor unit, you can adjust the position of the air flow blades, thus increasing the efficiency of the air conditioner. 1 Press the Swing button. Result: Result: x The blades are moving between up and down. When the air conditioner is first turned on, the blades are moved. IMPORTANT 2 To stop the blades, press the Swing button again. To set to the required position, press the Swing button again. When the blades are in the required position. [. . . ] Secure the bio-pure filter with four screws. Reinstall the air filter, the front grille and the safety clips. yyyy ;;;; yyyy ;;;; yyyy ;;;; E-31 Temperature and Humidity Ranges The following table indicates the temperature and humidity ranges, within which the air conditioner can be used. The automatic protection feature may be triggered and the air conditioner stopped. A water leakage or some other malfunction may happen if the heat exchanger freezes. [. . . ]