User manual LG LS-N3661AL

[. . . ] ENGLISH ITALIANO ESPAÑOL FRANÇAIS DEUTSCH GREEK Room Air Conditioner OWNER'S MANUAL · Please read carefully and thoroughly this manual before operating this unit. · Contact the authorized SVC man for repair or maintenance of this unit. · Contact the installer for installation of this unit. · The appliance is not intended for use by young children or infirm persons without supervision. [. . . ] The cooler or warmer you feel, the more times (up to two times) you should press the button. The set temperature will then be changed automatically. To raise the temperature Troubleshooting Tips To lower the temperature During Auto Operation: You cannot switch the indoor fan speed. It has already been set by the Fuzzy rule. If the system is not operating as desired, manually switch to another mode. The system will not automatically switch from the cooling mode to the heating mode, or from heating to cooling, it must be done by manually resetting. During Auto Operation, pressing the chaos swing button makes the horizontal louvers swing up and down automatically. If you want to stop auto-swing, press the chaos swing button again. 8 Healthy Dehumidification Operation ENGLISH 1 Press the Start/Stop button. The unit will respond with a beep. 2 Open the door on the remote control. To select Healthy Dehumidification Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the arrow. Cooling Auto Healthy Heating Dehumidification (Heat pump model only) 3 Set the fan speed again with the door of the remote control still closed. You can select the fan speed in four stepslow, medium, high, or CHAOS. Each time the button is pressed, the fan speed mode is shifted. Natural wind by the CHAOS logic For more fresh feeling than other fan speed, press the Indoor Fan Speed Selector and set to CHAOS mode. The unit will respond with a beep. 2 Press the Jet Cool button to operate the speed cooling mode and the unit will operate in super high fan speed on cooling mode for 30 minutes. 3 To cancel the Jet Cool mode, press the Jet Cool button again or the fan speed button or the room temperature setting button and the unit will operate in high fan speed on cooling mode. or or NOTE: During the JET COOL function at any moment, the A/C starts to blow the cool air at extremely high speed for 30 minutes setting the room temp. It is especially used to cool the room temp. In heat pump mode or neuro fuzzy mode however, the JET COOL function is not available. In order to return to the normal cooling mode from the JET COOL mode, you just press either the operation mode selection button, airflow volume selection or temp. setting button or the JET COOL button again. 11 Safety Precautions PLASMA Purification Operation(Option) 1 Press the Start/Stop button. The unit will respond with a beep. Operating Instructions 2 Open the door on the remote control. Press the PLASMA air purifying operation ON/OFF button. Operation will start when the button is pressed and stop when the button is pressed again. PLASMA Care and Maintenance 3 Set the fan speed again with door of the remote control closed. You can select the fan speed in four steps-low, medium, high or CHAOS. Each time the button is pressed, the fan speed mode is shifted. [. . . ] Remove the batteries from the remote control. Check that the air inlet and outlet of the indoor/outdoor unit are not blocked. Care and Maintenance Operation Tips Do not overcool the room. Do not let direct sunshine enter the room when the air conditioner is in operation. Adjust the vertical and horizontal airflow direction to ensure a uniform temperature in the room. This is not good for the health and wastes electricity. Troubleshooting Tips Make sure that the doors and windows are shut tight. Avoid opening doors and windows as much as possible to keep the cool air in the room. Clean the air filter regularly. Ventilate the room occasionally. [. . . ]