User manual LG LS-P1260AB

[. . . ] - To reduce the risk of damage, electric shock, and fire, Introduction Front 1. Headphone Connector The sound output terminal enables you to plug stereo headphones into the drive. Headphone volume control This headphone volume control adjusts the volume for your headphones. You can only use the headphone jack and volume control when you have installed the required software utilities. [. . . ] Refer to the documentation supplied with your sound card. Master/slave select terminal Usually, this is a pre-set configuration as illustrated below. Verify that the setting is as illustrated. If it is not, simply remove the jumper and place it in the correct position. Interface terminal This input/output interface terminal is used to connect the 40-pin flat cable from the IDE interface to the CD-ROM drive. Power terminal The power terminal is a four-conductor male plug. (A : +5V DC) (B : +12V DC) Setup Installing the CD-ROM Drive To install your CD-ROM Drive in the PC, proceed as follows. Make sure that the PC is powered off and disconnected from any power source. If necessary, attach a horizontal bracket to both sides of the drive. Remove the cover from a free expansion slot and install the CD-ROM drive, as shown in the illustration. Connecting the Cables Setup Connecting the power cable The 4-pin power cable from the internal power unit of your computer must be connected to the power terminal on the rear of the CD-ROM drive. 1 +5V DC A - Cut Side 2 Ground 3 Ground 4 +12V DC Note: An improperly connected power cable may cause trouble. Check the direction of the power connector and the incline side of the CD-ROM drive before connecting. Connecting the IDE cable Insert the IDE cable (40-pin), which is connected to the hard disk to the interface terminal. Store a disc vertically in a well-ventilated and stable location. Do not write or attach a label on a disc. Do not drop a disc or place heavy objects on it. Do not touch the surface of a disc; hold it by the edges. To clean a disc, polish lightly from the inside of the disc to the outside with a soft cotton cloth. Do not leave the disc compartment open when you are not using it. Using the Drive Upgrading the Firmware Flash Memory The product firmware can be upgraded by downloading the updated file from the following Web site: http://samsung-ODD. com http://samsung. com System Requirements Before you install the CD-ROM drive, we strongly recommend that you check that your setup meets the system requirements listed below. Item Type of computer Free expansion unit Disk space MS-DOS version Windows version Description Intel Pentium II 166MHz(or higher), 16 MB of RAM (or higher) with an IDE interface 5. 25 inch 100MB minimum 5. 0(or higher) Windows 95 / 98 / 2000 / ME / XP Windows NT 4. 0 (or higher) Troubleshooting Problem The CD-ROM drive is not detected by the computer. After installing the CD-ROM drive, the PC gets slower. Meaning / Solution Check that the power, audio and IDE cables are correctly connected to the computer. Change the IDE cable and reconnect it to the computer. Preferably, connect a second IDE cable to the CD-ROM drive in master mode. Check the position of the jumper in the master/slave select terminal. The CD-ROM drive is not recognized by MS-DOS. Reinstall the device driver or update it with the latest version by downloading it from the Samsung Web site. [. . . ] If you select DIGITAL at CD Audio Play in Media Player of Windows ME/XP, the earphone does not appear in the Digital Mode. The CD-ROM drive is not detected by Windows. No sound is heard from an audio CD. A CD is not read or is read too slowly. The disc compartment will not open. Check whether the CD is of good quality and clean it, if necessary. Check that the power cable is correctly connected. [. . . ]