User manual LG LSNC306DGB3

[. . . ] All safety messages will be preceded by the safety alert symbol and the hazard signal word DANGER, WARNING, CAUTION. These words mean: DANGER WARNING CAUTION You will be killed or seriously injured if you don't follow instructions. You can be killed or seriously injured if you don't follow instructions. Indicates an imminently hazardous situation which, if not avoided, may result in minor or moderate injury, or product damage only. All safety messages will identify the hazard, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. w DANGER: RISK OF CHILD ENTRAPMENT Child entrapment and suffocation are not problems of the past. [. . . ] This drawer can be used for large party trays, deli items, or beverages. (but this drawer can't be used for vegetable. ) w CAUTION : The glass shelf over the crisper is not firmly secured. Be careful when tilting. REMOVING CRISPER 1. To remove, pull the drawer out to full extension. Lift the front of the crisper up, then pull it straight out. To install, slightly tilt up the front and insert the drawer into the frame and push it back into place. Controls The control regulates the air temperature in the drawer. Set control level to COLD (print on surface) to provide normal refrigerator temperature. Use the COLDER (print on surface) setting for meats or other deli items. NOTE: Cold air directed to the Glide`N'Serve can decrease refrigerator temperature. Refrigerator control may need to be adjusted. To replace Glide`N'Serve 1 To remove the glass 1. To install, insert the Durabase in rail assembly. PULL OUT DRAWER To separate the drawer, push the front left and right hooks in direction to pull up and remove. Then gently lift the gear part of rear left and right side of the drawer and pull it out in direction. 1 3 2 1 2 To install, reposition the gear part of rear left and right side of the drawer after pulling out both rails as much as possible, and gently push down both left and right side while checking the hook on the front part. Hook 25 USING YOUR REFRIGERATOR FILTER It is recommended that you replace the filter when the water filter indicator icon turns on or your water dispenser or ice maker performance decreases noticeably. Take the new cartridge out of its packaging and remove protective cover from the o-rings. With cartridge knob in the vertical position, push the new filter cartridge into the cover until it stops. After changing the water filter cartridge, reset the water filter status display and indicator icon by pressing and holding the Filter Reset button for 3 seconds. Place a container under the hole of filter holder. If you can't turn the filter from side to side, it isn't fully inserted. Push it in firmly and twist it into place. You will hear the snap when it clicks into place. Using its handle, twist the cartridge clockwise about 1/4 turn. You will hear the snap when it clicks into place. NOTE: When filter is being removed, the water drains through the hole. Rotate the knob of the cartridge counter clockwise. 3. Flushing the Water System After Replacing Filter Dispense water through the water dispenser for 3 minutes to purge the system. Pull out the filter cartridge. 26 CARE AND CLEANING w WARNING PLASTIC PARTS (covers and panels) Do not use window sprays, abrasive cleansers, or flammable fluids. These can scratch or damage the material. CONDENSER COILS Remove Back cover. [. . . ] Call a plumber to clear the valve. The door is reopened within a short time after having been opened. Clean gaskets and the surfaces that they touch. Rub a thin coat of appliance polish or kitchen wax on the gaskets after cleaning. When you open the door, warmer air enters the refrigerator. As the warm air cools, it can create a vacuum. [. . . ]