User manual LG LST-5402P

[. . . ] Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. REGULATORY INFORMATION: FCC Part 15 This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] Remove the lens mount cap from the camera. CS mount type lens Carefully align the lens mount with the camera opening, then turn the lens slowly to install it. C mount type lens To allow for flange- back adjustment, install the C-mount adaptor (option) on the lens mount, then carefully align the lens mount with the camera opening and turn the lens slowly to install it. e t Connect the lens plug to the lens iris output connector (LENS) on the side of the camera. When using lenses from other makers, the plug shape may not correspond to the terminal on the camera. In such a case, remove the original plug and using a soldering iron, connect a lens iris plug according to the diagram. (Refer to next page. ) 1 2-2 3 2-1 13 Mounting the Lens Pin layout for the lens iris output connector C Rewire the lens iris plug 1. Cut off the plug of the lens cable, cut off approximately 8mm of the insulation, and then strip approximately 2mm of the ends of the cable sheaths. D A po to Sw CA le 8mm 2mm No. 1 2 3 4 DC type lenses Damping Damping + Drive + Drive - VIDEO type lenses Vcc (+9V) Not used Video Ground 2. Solder the ends of the cable wires to the ends of the pins, and then attach the cover of the lens iris plug. 14 Concerning Auto-Iris Lenses DC type auto-iris lens A lens without driver circuit that operates only on a DC power source. In general, this type of lens is referred to as DC type coil lens. (Set the ALC Lens Setting Switch to the DC position. ) CAUTION: Depending on the type of lens used, the lens may not perform properly. ELC type auto-iris lens Use a manual or fixed iris lens (Set the ALC Lens Setting Switch to the ELC position. ) s 15 Concerning Auto-Iris Lenses VIDEO type auto-iris lens A lens with amplifier circuit that operates on video signal and DC power source. Use · · · or button to select a mode then press . WDR LIMIT: LOW y MIDDLE y HIGH BLC LIMIT: LOW y MIDDLE y HIGH BLC: Set the BLC limit. HSBLC: Use for adjusting brightness the specific area of picture. AREA SETTING: Use or button to select a area or button to select a ON or OFF. Press then use to exit the Area setting menu. 24 Exposure Settings GRAY SCALE: Use or button to select a gray scale. USER SCALE: Use level. (5 level) or button to select a bright Brightness setting You can set the brightness level. Use or button to set the bright level. AGC (Automatic Gain Control) setting If the images are too dark, change the maximum [AGC] value to make the images lighter. (OFFy LOWyMIDDLEyHIGH) 25 Exposure Settings SHUTTER (Shutter Speed) setting 1. (AUTOy OFF y A. FLK y 1/160 ~ 1/90000 y x512~x2) W SENS-UP setting If pictures are not clear due to darkness, use for increase the sensitivity of picture. Use or button to select [SENS-UP] option. or button to select a [AUTO]. Use To setting the [AUTO] funtion, select the [AUTO] on the [SHUTTER]. [. . . ] Use · · or button to change a color effect. ON: Color screen OFF: B/W (Black and White) screen Setting the SYNC (Synchronization) You can select internal sync (INT) mode or line-lock (LINE) mode. The SYNC function is available only with AC power source. Select [SYNC] option on the [SPECIAL] menu. [. . . ]