User manual LG LSW220BX

[. . . ] T * nstall the screw to attach the wall mount so that it can be assembled at the center from both ends of I the studs. Use of stud finder, a separate device, is recommended. * Install the product only on a vertical wall. [. . . ] and, set the angle adjusting part to face upward. Align the wall mount bolts to the holes and tighten them by hand. Then, fasten the bolts at a torque of 45 - 60 kgf/cm. 3 How to install the wall mount <When installing on a masonry wall> →  hen you separate the 8 screws on the wall mount connected to the wall bracket for use with a wooden wall, it is much easier W to install the product. A A →  hen installing the product on a masonry wall, turn the 8 W screws on the A part counterclockwise to separate the screw and bracket. →  fter aligning the wall bracket to the location to install, A mark the part to screw on the wall and then remove the wall bracket. → Refer to page 4 to attach the wall bracket. → Use a level to check whether the wall mount is level. Separate the wall mount screw. 4 Wall mount screw →  the screw cannot be assembled in the designated location If inevitably, it can be assembled by rearranging to the closest location. But, do not change 2 or more locations from the designated spot. →  ssemble the wall mount screw on 1 left and 1 right location A on the top part and 1 left and 1 right location on the bottom part. →  t this time, use a Phillips Head driver (Manual or motorized) A or 8mm wrench to tighten the screw so that the wall, wall bracket and screw are completely pressed against one another. <When mounting to wooden studs> 76mm drywall 406mm wood stud drywall a. Locate and mark the centers of the wall studs using a stud finder.  fter aligning the wall bracket on the wall where the center of the wood stud is marked, mark the location of the screws and A then remove the wall bracket. Use a level to make sure your screw marks are level. Use the 4mm drill bit for wood to drill holes with the depth of 76mm or above where the wall mount screw location is marked  on the wall. [. . . ] *C   aution : Prevent the power cord from being pinched between the wall mounting bracket and the set when installing the set. (A pinched power cord may cause an electrical short) ENGLISH Do not put pressure on the display panel The display panel on Cinema Screen models (LM64**, LM66**, LM67**, LM76**, LM86**) can be easily damaged by pressure or shock. For more information, please refer to the owner's manual of the TV. 5 How to level the Display After installing the display, check to make sure it is level. [. . . ]