User manual LG LSW630B

[. . . ] *  his product is designed to be mounted to walls that use standard intervals between the studs. T * nstall the screw to attach the wall mount so that it can be assembled at the center from both ends of I the studs. Use of stud finder, a separate device, is recommended. [. . . ] (When inserting the anchor, use a hammer. ) d.  et the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part to face S upward. Align the wall mount bolt to the hole and tighten it. Then, fasten the bolts at torque of 45 kgf/cm - 60 kgf/cm. 4 <When installing on a masonry wall> → f it’s not possible to use the indicated bolt holes, use I  the closet ones. Don’t go more than two away from the indicated position. →  Attach the right and left side with two bolts each. → Use a Phillips head "+" driver (Manual or motorized)  or 8 mm wrench to tighten the screws. Tighten each screw until the set, guide spacer, and the screw are fully pressing against one another. Wall mount screw h w <When mounting to wooden studs> 76 mm drywall 406 m m wood stud drywall an a. Locate and mark the centers of the wall studs using a stud finder.  fter aligning the wall bracket on the wall where the center of the wood stud is marked, mark the location of the screws and A then remove the wall bracket. Use a level to make sure your screw marks are level. Use the Ø4 mm drill bit for wood to drill holes with the depth of 76 mm or above where the wall mount screw location is  marked on the wall. Tighten the wall mount screws for the wall bracket on the drilled hole. [. . . ] - When you adjust the angle, hold the product carefully with both hands to avoid any damage to the product or wall. ❶ 15± 2 ❸ ❹ ❶<Top Tilt> ❷<Bottom Tilt> ❷ ❸<Left Tilt> ❹<Right Tilt> <Set Side> <Set rear> -  ome models may not tilt as much as show above. S -  se both hands when adjusting the angles. Do not place the hands on the TV’s back side or the wall mount while adjusting. [. . . ]