User manual LG LT-C366DLE0

[. . . ] *) Please contact your local authority for further details. It means that used electrical and electronic products should not be mixed with general household waste. There is a separate collection system for these products. If your used electrical or electronic equipment has batteries or accumulators, please dispose of these separately beforehand according to local requirements. [. . . ] ⷠThe unit can be affected by signals transmitted from the remote control of a television, VCR or other equipment used in the same room. ⷠDo not leave the remote control in direct sunlight or near a heater. Also, protect the unit and remote control from moisture and shock which can discolour or damage them. Example: 5 o'clock in the afternoon 1 To set to the 12-hour mode, press the CLOCK button once in the first step. To set to the 24-hour mode, press the CLOCK button twice in the first step. The current time cannot be set when the timer is operating. In the AUTO and DRY modes, the temperature can be changed C in 1°C increments within the range of 2°C (Example: 2°C lower) higher to 2°C lower from the temperature automatically deterC mined by the air conditioner. ⷠIn the COOL and HEAT modes, the temperature can be set within the range of 18 to 32°C In the DRY mode, the fan speed is preset to AUTO and cannot be changed. 5 To turn off the unit, press the ON/OFF button again. When using your air-conditioner with multi-system (GS-XPM9FGR , GS-XPM12FGR , GS-XPM18FGR) With a multi system air conditioner , multiple indoor units can be connected to one outdoor unit. When the setting mode differs among indoor unit(s), the indoor unit(s) operated later may not work. During heating operation When outlet air temperature is low, air is blown out from upper air outlet to prevent cold air blowing to the floor. When outlet air temperature becomes high, air is blown out from both air outlet with main air flow from lower outlet to deliver warm air to the floor. In this operation, the air conditioner works at maximum power to make the room cool or warm so rapidly that you can use it just after you come home. FULL POWER operation will also be cancelled when the operation mode is changed, or when the unit is turned off. You cannot set the temperature or fan speed during the FULL POWER operation. When the ONE-HOUR OFF TIMER is set, the unit will automatically turn off after one hour. The orange TIMER lamp ( ) on the unit will light up. ⷠThe unit will stop operating after one hour. Alternatively, turn the unit off by pressing the ON/ OFF button. ⷠThe red OPERATION lamp ( ) and the orange TIMER lamp ( ) on the unit will turn off. If the ONE-HOUR OFF TIMER is set while the unit is not operating, the unit will operate for an hour at the formerly set condition. [. . . ] The unit will not operate immediately after the mode is changed. This is to protect the internal mechanisms. Wait 3 minutes before operating the unit. The soft, swishing noise is the sound of the refrigerant flowing inside the unit. [. . . ]