User manual LG LT-E1862CL

[. . . ] Revised pages: cover, 110, 111, 112, 113. R410A PRINTED IN JAPAN, Jul. , 2005 ToMo CONTENTS 1. SPECIFICATIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . REFRIGERANT R410A . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . CONSTRUCTION VIEWS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] · There is no relation between A setting/B setting and A room/B room when connecting the piping and cables. Do not put the drain hose end into water. Do not put the drain hose end in the drainage ditch. Fig. Put water in the drain pan and make sure that the water is drained outdoors. When connecting extension drain hose, insulate the connecting part of extension drain hose with shield pipe. Shield pipe (local parts) Drain hose Inside the room Extension drain hose Fig. 9-2-15 CAUTION Arrange the drain pipe for proper drainage from the unit. Improper drainage can result in dew-dropping. 9-2-7. Pass the pipe through the hole in the wall, and hook the indoor unit on the installation plate at the upper hooks. Swing the indoor unit to right and left to confirm that it is firmly hooked up on the installation plate. While pressing the indoor unit onto the wall by the lower part, hook it up on the installation plate by the lower part. Pull the indoor unit toward you by the lower part to confirm that it is firmly hooked up on the installation plate. 1 1. Setting of remote controller switch at the indoor unit side · Remove the front panel. (1) Before you open the front panel, be sure to turn off the circuit breaker or the main power switch. * To reset [A] setting, push the [MODE] button again while pusing the [CHK] button. 9-2-9. Check the unit is firmly hooked up on the ¨ ¨ ¨ ¨ ¨ ¨ installation plate. Check the connecting pipes tightened securely. Confirm that all connecting cables are secured and correct. To switch the TEST RUN (COOL) mode, turn the switch on. To switch the TEST RUN (COOL) mode, press TEMPORARY button for 10 sec. (The beeper will make a short beep. ) 3. Confirm the indoor unit can operate with the changed setting of the remote controller. MODE TEMP . AUTO COOL DRY FAN ONLY FAN AUTO Hr. ON OFF TIMER B C LOW MED. HIGH B C TEMPORARY button TEMPORARY TEMP. START/STOP SET FAN ECONO. Fig. Operate the unit at cooling operation mode for fifteen minutes or more. Measure the temperature of the intake and discharge air. [. . . ] (M10YKCV-E) P Board Ass'y, MCC-772 . C. 409 410 411 412 413 414 43T69048 43T69049 43T69050 43T69069 43T61001 43T62006 Description P. C. Board Ass'y, MCC-772 (M16YKCV-E) P. C. Board Ass'y, MCC-772 (M10YKV-E) P. C. [. . . ]