User manual LG LT20-476A

[. . . ] D It is recommended to contact a service center directly. ever spill any kind of liquid on the air conditioner. N DURING OPERATION If this happens, unplug or turn off the air conditioner and contact an authorized service center. o not insert anything between the airflow blades to prevent damage D of the inner fan and consequent injury. Keep children away from the air conditioner. o not place any obstacles in front of the air conditioner. D o not spray any kind of liquid into the indoor unit. [. . . ] Result: The operation indicator on the indoor unit lights up. The air conditioner starts up in the mode you selected last. Press the button on the remote control until is displayed. Result: The indoor unit beeps each time you press the button. The air conditioner runs in the Cool mode. Note You can change modes at any time. 2 3 Press the button to adjust the temperature until the required temperature is displayed. You can set the temperature between 16°C and 30°C. Result: ach time you press the E button: - The temperature is adjusted by 1°C - The indoor unit beeps f the room temperature is higher than the selected I temperature, the air conditioner starts cooling. the room temperature reaches the set temperature, the If air conditioner stops cooling, but the fan operates consistently. 4 Press the displayed. button to select the fan speed until the required settingis Automatic (rotated : Low Medium High Maximum ) Result: Each time you press the button, the indoor unit beeps. he fan speed indicator increases and decreases T continuously and turns round each time you press the button. 5 To control the airflow direction, refer to page 15. E-10 Selecting the Dry Mode ENGLISH You can select the Dry mode if you want to dehumidify your room. You can adjust the temperature in this mode. 1 If necessary, press the (On/Off) button. ou can select the Turbo function in the Auto and Cool mode. Y If you select this function in the Dry or Fan mode, the mode changes to the Auto mode. 2 3 Press the button again to stop the Turbo Function before the end of the 30-minute period. Result: The air conditioner is reset automatically to the previous setting. 4 To control the airflow direction, refer to page 15. E-13 Selecting the Energy Saving Function You can select the Energy Saving Function to save energy when cooling. 1 If necessary, press the (On/Off) button. Result: The operation indicator on the indoor unit lights up. The air conditioner starts up in the mode you selected last. The indoor unit beeps. 2 Press the button. The air conditioner runs in the Energy saving mode. The outer airflow blade moves up and down. To stop the Energy saving mode, press the again. Note You can select the Energy saving mode only in the Cool mode. 3 Press the button to adjust the temperature until the required temperature is displayed. 4 Press the displayed. button to select the fan speed until the required setting is 5 To control the airflow direction, refer to page 15. E-14 Adjusting the Airflow Direction Vertically ENGLISH You can adjust the airflow direction vertically. The outer airflow blade moves up and down to increase the efficiency of the cooling operation. 1 Press the button until the required direction is set. [. . . ] Water may leak and some malfunction may occur if the heat exchanger freezes. Water may condense and drip from the surface of the indoor unit if you don't use the air conditioner for a long time. Operation Cooling Dehumidifying Outdoor Temperature 19°C to 54°C approx. 19°C to 54°C approx. Indoor Temperature 16°C to 32°C approx. 16°C to 32°C approx. Indoor Humidity 80% or less - If you use the air conditioner over 32°C(indoor temperature), the cooling capacity may drop. Operating Your Air Conditioner Without the Remote Control You can operate your air conditioner directly without the remote control. 1 To turn the air conditioner on, press the On/Off button on the right side of the indoor unit. [. . . ]