User manual LG LTRM1240SW

[. . . ] Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. · A suitable conduit entries, knock-outs or glands shall be provided in the cable entries of this product in the end user. Caution: Danger of explosion if battery is incorrectly replaced. Replaced only with the same or equivalent type recommended by the manufacturer. [. . . ] If you want to control the focus manually, press the FOCUS (NEAR or FAR) buttons on the controller. ONE PUSH: The focus is activated manually. If the camera is received auto-focus command, the camera is activated auto-focus mode and the focus is set automatically and then the focus mode is automatically changed to manual mode. ZOOM TRIG: The focus is activated manually. If you change the zoom, the focus is activated automatically and then the focus mode is automatically changed to manual mode. Select the desired lens iris value for camera exposure. Select [IRIS] option on the [EXPOSURE] menu, then select a value. · · AUTO: The lens iris is set automatically. MANUAL: Use [Near] or [Far] button to select the DC Iris level. DC Iris level are set by one parameter unit. · AGC (Automatic Gain Control) setting If the images are too dark, change the maximum [AGC] value to make the images bright. Select [AGC] option on the [EXPOSURE] menu. Use [Near] or [Far] button to select a mode. · 38 Operation WDR/BLC setting Use WDR/BLC option to set the options for BLC or WDR camera. When the scene mostly contains high color Operation 39 temperature objects, such as a blue sky or sunset. AUTO: In this mode, the color temperature range for the proper white balance is approximately 2 700 K to 5 400 K. Proper white balance may not be obtained under the following conditions: When the color temperature is out of the 2 700 K to 5 400 K range. When the scene mostly contains high color temperature objects, such as a blue sky or sun set. When the scene is dim. - D/N LEVEL: Use [Near] or [Far] button to select a level. DWELL TIME: Use [Near] or [Far] button to select a dwell time. NOTE If you set the AGC to [OFF] or the SHUTTER is set to one of the SHUTTER options except AUTO on the [EXPOSURE] menu, the AUTO mode of the DAY/NIGHT function is not available and [---] mark is displayed. · · DAY: Color mode enabled. NIGHT: Black-and-white mode enabled. · ONE PUSH: If you select the ONE PUSH mode, you will be able to set up the White Balance automatically using [Open] or [Close] button. MANUAL: You can set the white balance options manually. COLOR TEMP: Use [Near] or [Far] button to select a function. > INDOOR: The color temperature range for the proper white balance is approximately 3 200 K. [. . . ] A (Blank): Insert a space at the cursor position. Operation 49 DOME ID setting Displays or removes the Camera ID OSD on the screen. ALARM Setting This camera has a terminal that can sense the alarm signals. The camera can be programmed to go to a preset with a signal from any connected alarm device. 1. Select [DOME ID] option on the [OSD] menu. Use [Near] or [Far] button to set it [ON] or [OFF] 3. [. . . ]