User manual LG LV220D

[. . . ] Warning: Wiring methods shall be in accordance with the National Electric Code, ANSI/NFPA 70. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. Warning: To reduce a risk of fire or electric shock, do not expose this product to rain or moisture. Caution: This installation should be made by a qualified service person and should conform to all local codes. [. . . ] Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 3 LV220D_HP_ENG_77T 6/13/07 3:41 PM Page 4 Important Safety Instructions 9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. Use only the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with apparatus. When a cart is used, use caution when moving the cart/ apparatus combination to avoid injury from tipover. Unplug this apparatus during lightning storms or when unused for long periods of time. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power- supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. 10. Use a commercially available Certified/Listed, Class 2, DC 12 V adaptor. Connect an DC 12 V power source to the DC 12V input terminal on the back of the camera with 3 and # aligned correctly as shown left. 1 3. Insert the plug of this power cord into a wall outlet. The POWER indicator will light. 8 LV220D_HP_ENG_77T 6/13/07 3:41 PM Page 9 Mounting the Lens 1. Remove the lens mount cap from the camera. CS mount type lens Carefully align the lens mount with the camera opening, then turn the lens slowly to install it. C mount type lens To allow for flange- back adjustment, install the C-mount adaptor (option) on the lens mount, then carefully align the lens mount with the camera opening and turn the lens slowly to install it. Connect the lens plug to the lens iris output connector (LENS) on the back of the camera. When using lenses from other makers, the plug shape may not correspond to the terminal on the camera. In such a case, remove the original plug and using a soldering iron, connect a lens iris plug according to the diagram. (Refer to next page. ) 9 1 2-2 3 2-1 LV220D_HP_ENG_77T 6/13/07 3:41 PM Page 10 Mounting the Lens Pin layout for the lens iris output connector Rewire the lens iris plug 1. [. . . ] (NTSC : 1/100 sec, PAL : 1/120 sec) Shutter speed is not fixed Auto mode Manual mode 4 * Factory Setting Note: When you switching the D&N function, noise may appears on the screen while changing filter. 13 LV220D_HP_ENG_77T 6/13/07 3:41 PM Page 14 Day&Night Function Settings Auto Mode The D&N function is activated automatically AGC ON mode. Set the D&N dip switch to D&N AUTO position on the rear panel. Notes : · It is not necessary to connect the D&N terminal to control D&N auto function. · If you use the IR illumination, the Day and Night function may be switch again and again. [. . . ]