User manual LG LW-A0560CS

[. . . ] Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. FCC COMPLIANCE STATEMENT Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Jumper Connector This jumper determines whether the drive is configured as a master or slave. Changing the master-slave configuration takes effect after power-on reset. 4. IDE Interface Connector Connect to the IDE (Integrated Device Electronics) Interface using a 40-pin flat IDE cable. NOTE : Do not connect or disconnect the cable when the power is on, as this could cause a short circuit and damage the system. Always turn the power OFF when connecting or disconnecting this cable. 5. Power Connector Rear Panel (For Serial ATA drives) 12 1. SATA connessione per l'alimentazione (15 pin) 2. SATA connessione dati (7 pin) The drive's appearance and specifications may change without prior notice. 3 Installing the Drive (For ATAPI/E-IDE drives) Before installing the drive, please note the following points. You will need the following: · A screw driver of a suitable size to fit the securing screws for the drive unit. · The manual for the computer, so you can find the mounting positions for the IDE controller cable. Turn off all peripheral appliances of the computer and the computer itself, and disconnect their power cords from the wall sockets. Beveled edge up Connecting the Interface Connector Connect the 40-pin IDE cable to the back of the Drive, making sure the coloured (red) stripe on the IDE cable is connected to pin 1 on the drive. Pin 1 is closest to the Power Connector. Pin1 NOTE : Generally, the IDE connector is keyed and will only fit one way. Red-edge 6 Connecting the Sound Card If the computer is using a sound card, the drive is connected to the sound card with an audio cable. The supplied analog audio cable fits most sound cards or one can be purchased at a local computer store. INTER marking L-R Refer to the manual for the sound card for detailed information regarding this connection. L R Replacing the Computer Cover When the installation of the drive unit is complete, replace the computer cover Sound card Installing the Drive (For Serial ATA drives) Mounting the Drive 1 1. Remove the a 5 /4 drive bay panel from the computer. Refer to the manual for the computer for details. Do not apply excessive pressure to the cables inside the computer. If there is not much space behind the drive, connect the SATA and other cables before securing the drive. READ WRITE READ WRITE NOTE : This is a general installation guide. If your PC hardware appears different, please consult your hardware manual for installing peripheral devices. 7 PC Connection The drive connects to the motherboard of the host computer using a SATA interface cable. Connecting the SATA Power Cable Connect the power cable so the projection of the cable connector side to come to the left side. NOTE : Improper connection may damage the drive and void the warranty. Generally, the power connector can only fit one way. Red Connect to the power connector of the PC. Connecting the SATA Data Cable Connect the data cable. NOTE: Don't use this feature except in an emergency. [. . . ] (label up) · Is the drive installed in the correct orientation?· Was the drive or disc moved from a low temperature environment to a high temperature environment?(There is a possibility of condensation on the lens in the drive or on the surface of the disc. ) · · When you call for service, be prepared to give as much information as possible of your system, environment, and the specific problem. Were there any error messages displayed? [. . . ]