User manual LG LW130W

[. . . ] OWNER'S MANUAL HD Compact Network Camera Please read this manual carefully before operating your set and retain it for future reference. MODEL LW130W 1202 (V1. 2) Safety Instructions The following instructions and guidance are for your safe and proper use of the products to prevent damages on properties and injuries. Handling of the Product · Make sure any water or other fluid does not enter the device, as well as metallic objects or any other conductive substances. Fire or electric shock is feared if any fluids or metallic objects enter the device. · When cleaning the dusts or other foreign objects off the device, use dry clothes to wipe out the surface gently. When the contamination is heavy, use clothes soaked in neutral detergents. [. . . ] Click on the edge of the frame and drag to adjust the size as necessary. · To activate the motion detection functionality, either of the Master or Slave setting should be activated by activating the [Enable] Item. Also the video codec should be set at H. 264 and the value of GOP should be 2 or higher to allow the motion detection mode to function. Network Basic General > MAC Address: Shows the MAC address of the device. Port & Encryption > Web Port: The typically used port number for HTTP service is 80. We recommend that you change the number to anything between 1, 025 and 65, 535. 39 Initial Configuration and Operation > RTSP Port: The number of RTSP port for video streaming. The default value of the port number is 554, and you may change this within the range from 1, 025 to 65, 535. Network Encryption: Choose between HTTP or HTTPS for network encryption setting. Note: The RTSP port number must differ from the web port number. ARP Ping > Enable ARP ping to configure IP address: Select whether you wish to use ARP Ping for IP address setup using IP Utility. RTP Stream RTP (Real Time Transport Protocol) is an internet protocol that supports the transmission and management of the multimedia data in real time via unicast or multicast. > · Save: Click this button to save the changes you made. 40 Initial Configuration and Operation Master / Slave > > RTP Unicast: Check this radio button when you are using RTP unicast. RTP Multicast: Check this radio button when you are using RTP multicast. Video RTP port: Set the number of Video RTP port. The range of the possible port number is from 1, 025 to 65, 534. Audio RTP port: Set the number of Audio RTP port. The range of the possible port number is from 1, 025 to 65, 534. Data RTP port: Set the number of Data RTP port. The range of the possible port number is from 1, 025 to 65, 534. IP Address: Set the IP address for RTP multicast. The range of the possible address is from 240. 0. 0 to 239. 255. 255. 255. Note: When using multicast, avoid using the same port number with the multicast to prevent the video stream from overwrapping. Also, use unique IP addresses and port number for each device, or there might be IP address collision between the devices. TTL > TTL: Set the TTL(Time To Live) value. The default setting is 7, and the possible range of the value is from 1 to 225. - · Save: Press this button to save any changes you made. - - 41 Initial Configuration and Operation TCP/IP Note: To use this functionality, the mail server should be registered within the event server configuration. > Statically set: Manually configure the network settings. [. . . ] · If you cannot access to the multicast streaming, check the multicast settings. The IP address and port number should not be the same with any other device. Also, set your router or other network equipment to support multicasting by contacting your network administrator. · If you see grey lines in the video, update the driver software of your graphic card to the latest version. [. . . ]