User manual LG LWH246NBAB3

[. . . ] Do NOT insert anything between the air flow blades, as the inner fan may be damaged and you may be hurt. Keep children away from the indoor unit. Do NOT place any obstacles in front of the outdoor unit. If the remote control will not be used for a long time, remove the batteries. [. . . ] The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Plugged in x Stopped It will start up normally after a three-minute rest period. IM IMPORTANT 2 If the indication is not displayed at the top of the remote control, press the MODE button on the remote control one or more times until it appears. x The indoor unit beeps each time you press x The air conditioner starts up in Cool mode. N o t e You can change modes at any time. Result: MODE . MODE TURBO OFF 3 To adjust the temperature, press the or buttons one or more times until the required temperature is displayed. Possible temperatures are between 18°C and 30°C inclusive. Result: x Each time you press or : - The temperature is adjusted by 1°C - The indoor unit beeps x The air conditioner starts cooling, provided that the room temperature is higher than the selected temperature; the fan will, however, operate. MODE TURBO OFF 4 Select the fan speed by pressing the until the required setting is displayed: Low Medium High Automatic Result: Each time you press button one or more times , the indoor unit beeps. 5 To control the direction of the air flow, refer to page 15. E-10 Heating Your Room You must select the Heat mode if you wish to adjust the: x Heating temperature x Fan speed when heating 1 If necessary, press the Result: (On/Off) button. ENGLISH x The OPERATION indicator on the indoor unit comes on. x The air conditioner starts up in the mode selected when the unit was last used. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Plugged in x Stopped It will start up normally after a three-minute rest period. MODE TURBO OFF IM IMPORTANT 2 If the indication is not displayed at the top of the remote control, press the MODE button on the remote control one or more times until it appears. Result: x The indoor unit beeps each time you press x The air conditioner starts up in Heat mode. N o t e You can change modes at any time. MODE . MODE TURBO OFF 3 To adjust the temperature, press the or buttons one or more times until the required temperature is displayed. Possible temperatures are between 16°C and 30°C inclusive. To stop the blade moving up and down, press the button again. 2 3 Adjust each set of inner blades to the required position, by pushing or pulling them sideways. Switching the Unit On and Off Automatically (On/Off Timer) You can set the timer to switch the air conditioner on and/or off automatically at given times. Example: You wish to start cooling your room before you return from work; you decide to: x Switch the air conditioner on at 5:30 p. m. You can set: x The switch-on time only x The switch-off time only x Both the switch-on and switch-off times IM IMPORTANT Check that the current time is correct before setting the timer; if it is not correct, refer to page 8 for details on how to set it. (On/Off) button. 1 2 If necessary, press the Select the required mode by pressing the MODE button on the remote control one or more times until the appropriate indication appears (in the above example, ). Press the Result: Note button under the cover on the remote control. If you do not press a button within a few seconds, the Timer function is cancelled and you must press the button again. Hold down the w button. MODE TURBO OFF 3 4 To set the switch-on time, press the To. . . Increase the time in ten-minute intervals Increase the time in one-hour intervals Decrease the time in ten-minute intervals Decrease the time in one-hour intervals Result: 5 AM or PM is displayed to indicate whether the setting corresponds to a time before or after midday. . When you are satisfied with the switch-on time, press Result: Note x The indoor unit beeps. x The TIMER indicator on the indoor unit lights up yellow. If not necessary to operate the air conditioner until the set up time for starting, press (On/Off) button off. [. . . ] Problem The air conditioner does not operate at all Explanation/Solution x Check that the breaker used for the air conditioner is switched on. x Check that the OPERATION indicator on the indoor unit is on; if necessary press (On/Off) on the remote control. x Check whether the TIMER indicator on the indoor unit is switched on. If so: - Wait until the switch-on time is reached and the air conditioner starts up automatically - Cancel the timer (see page 19 for further details) x Check that there are no obstacles between you and the indoor unit. [. . . ]