User manual LG LWHD1006R

[. . . ] Off ( O ) turns the air conditioner off. NOTE: If you move the switch from a cool setting to off or to a fan setting, wait at least 3 minutes before switching back to a cool setting. Operating Instructions Cooling Descriptions THERMOSTAT (TEMPERATURE) The THERMOSTAT/TEMPERATURE is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the same level of comfort. When you turn the knob to a higher number (the right side) and the indoor air will become cooler. [. . . ] NOTE: If you move the switch from the cool(or the heat) setting to off or to a fan setting, wait at least 3 minutes before switching back to a cool(or heat) setting. Cooling Descriptions THERMOSTAT (TEMPERATURE) The THERMOSTAT/TEMPERATURE is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the same level of comfort. The temperature is selected by turning the THERMOSTAT/ TEMPERATURE knob to the desired position. For Normal Cooling- Select HIGH Cool with the OPERATION knob at the midpoint of the THERMOSTAT/TEMPERATURE knob. For Maximum Cooling- Select HIGH Cool with the OPERATION knob at the clockwise available on the THERMOSTAT/TEMPERATURE knob. For Quieter & Nighttime Cooling- Select LOW Cool with the OPERATION knob at the midpoint of the THERMOSTAT/ TEMPERATURE knob. Heating Descriptions For Normal Heating- Select HIGH heat with the OPERATION knob at the midpoint of the THERMOSTAT/TEMPERATURE knob. For Maximum Heating- Select HIGH heat with the OPERATION knob at the counterclockwise available on the THERMOSTAT/TEMPERATURE knob. For Quieter Heating- Select LOW heat with the OPERATION knob at the midpoint of the THERMOSTAT/TEMPERATURE knob. HEATER LAMP At the heating operation, the lamp is lighted. When the frost settles on the heat exchanger of the outside, defrosting is made automatically and the lamp is unlighted. After defrosting, the heating operation begins again. AUTO SWING Auto swing switch controls the horizontal air direction by air swing system (not on all models). OFF ( ) : Auto swing is not operated. -5- Operating Instructions Controls Precaution: The Remote Control unit will not function properly if strong light strikes the sensor window of the air conditioner or if there are obstacles between the Remote Control unit and the air conditioner. POWER BUTTON Operation starts, when this button is pressed and stops when you press the button again. To remove: Open the inlet grille upward by pulling out the bottom of the inlet grille or downward by pulling out the top of the inlet grille. Using the tab, pull up slightly on the filter to release it and pull it down or up. Clean the filter with warm, soapy water below 40°C (104°/F). Rinse and gently shake the water from the filter and let it dry before replacing it. CAUTION: DO NOT operate the air conditioner without a filter because dirt and lint will clog it and reduce performance. Drainage In humid weather, excess water may cause the BASE PAN to overflow. To drain the water, remove the DRAIN CAP and secure the DRAIN PIPE to the rear hole of the BASE PAN. To remove the condensed water, you can install the drain pan as below. Take the drain pan which is located in the air discharge. Install the drain pan to the right corner of the cabinet with 4 screws. Connect the drain hose to the outlet located at the bottom of the drain pan. You can purchase the drain hose or tubing locally to satisfy your particular needs. [. . . ] Restriction of outside air will greatly reduce the cooling efficiency of the air conditioner. Install the unit a little obliquely outward not to leak the condensed water into the room (about 10 ~ 15mm or 1/4 bubble with level). CAUTION: All side louvers of the cabinet must remain exposed to the outside of the structure. 9. 15. CONTROL BOARD POWER CORD COMPRESSOR BASE PAN BRACE CONDENSER PLASMA FILTER ASSY. Installation Instructions Remove the Air Conditioner From the Case Remove the 2 shipping screws from the back of the case. [. . . ]