User manual LG LWM1835BXP1

[. . . ] Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. REGULATORY INFORMATION: FCC Part 15 This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] The users from these IP addresses need to be specified in the user list with the appropriate access rights. The IP list is to control the access permission of clients by checking the client IP address. · Add: Click this button to add the IP address. From: Enter the start IP address for the IP filtering. To: Enter the end IP address for the IP filtering. Note: If you want to deny or to allow a range of IP addresses, enter the start IP address to "From" and the end IP address to "To". You can also add an IP address by entering the same IP address to "From" and "To". Repeat the steps 1 to 3 to add additional IP address. · Remove: Click this button to delete the IP address. The IP address will be deleted. IP list > Basic policy: Select the basic policy type. Allow all: Allow all the IP address basically, but the IP addresses in the list are denied. Deny all: Deny all the IP address basically, but the IP addresses in the list are allowed. It needs at least one IP address to activate this function. · Save: Click this button to confirm the settings. 36 Operation and settings User settings Basic The IP device is shipped with the login rights of administrator only. > Never: [Always] and [Recurrence Pattern] recording functions are not activated. 38 Operation and settings > Overwrite: If the micro SD card has insufficient space and this option will be activated. > DiskFull Notification: Sends an warning e-mail to the SMTP server when the micro SD card has fully recorded. Select the SMTP server from the drop-down list. You should register the SMTP server on the Event server setting to set this function. > Network Failure Recording: Select the checkbox to activate the micro SD card recording function. If the system does not work with recording server, the system will record the data to the micro SD Card. When the system connect to the recording server again, the recorded data of the micro SD card will transfer to the recording server automatically. > Recording Server IP: Enter the rcording server IP. > Set as NTP server IP: Click this button to use the entered Recording Server IP as the NTP server IP. > Stream: Select the stream type for the recording. Notes: The recorded file name is made automatically as the "[Created date of the file]_[GMT Recording Time]+(-)[Value of the Local Time minus GMT Time (Second)]_[Use or not of the Daylight saving time(N/D)][Stream index][DeleteFlag]. [. . . ] Select the Night mode if the network camera is connected at a place where surrounding light is less or dark. Reference 57 · · · · If we obtain lower frame rate than set we need to check from the system administrator for sufficient bandwidth available or reduce the number of applications running on the client computer. If the client PC's are unable to access the multicast stream, check with the system administrator for the use of a valid multicast address or check if the router is supporting multicasting. If the images appear to have white of gray stripes on it, upgrade the Video graphics driver on the client PC to the latest version. Video images may be noisy if you are using the camera in a very low light environment or the bit rate/quality is set to very low values. [. . . ]