User manual LG LXA1010ACL

[. . . ] A service technician to instruct the user in correct product installation, operation or maintenance. A service technician to clean or maintain this product. Damage to or failure of this product if it is not installed, operated or maintained according to all instructions supplied with the product. Damage to or failure of this product resulting from accident, abuse, misuse or use for other than its intended purpose. [. . . ] Do not use · Bread wrappers · Non-polyethylene plastic containers · Containers without tight lids · Wax paper or wax-coated freezer wrap · Thin, semi-permeable wrap w CAUTION: Do not keep beverage cans or plastic food containers in the freezer compartment. Freezing Your freezer will not quick-freeze any large quantity of food. Do not put more unfrozen food into the freezer than will freeze within 24 hours (no more than 2 to 3 lbs of food per cubic foot of freezer space). Leave enough space in the freezer for air to circulate around packages. Be careful to leave enough room at the front so the door can close tightly. Storage times will vary according to the quality and type of food, the type of packaging or wrap used (airtight and moisture-proof) and the storage temperature. Ice crystals inside a sealed package are normal. This simply means that moisture in the food and air inside the package have condensed, creating ice crystals. NOTE: Allow hot foods to cool at room temperature for 30 minutes, then package and freeze. Cooling hot foods before freezing saves energy. Holes Tabs REFRIGERATOR SECTION WATER DISPENSER Tray can be easily removed by pressing down and pulling out it. Tilt up the front of tray slightly and snap the tabs into the holes to reinstall the tray. w WARNING: Do not put your fingers up the ice chute opening. w CAUTION: Do not dispense ice into fine china or crystal glasses. Set control level to COLD (print on surface) to provide normal refrigerator temperature. Use the COLDER (print on surface) setting for meats or other deli items. NOTE: Cold air directed to the Glide`N'Serve can decrease refrigerator temperature. Refrigerator control may need to be adjusted. REMOVING HUMIDITY CONTROLLED CRISPER 1. To remove, pull the drawer out to full extension. Lift the front of the crisper up, then pull it straight out. To install, slightly tilt up the front and insert the drawer into the frame and push it back into place. MODULAR DOOR BIN The door bins are removable for easy cleaning and adjusting. Simply lift the bin and pull it straight out to remove it. To replace the bin, slide it in above the desired support button and push down until it stops. DAIRY BIN To remove the dairy bin, simply lift it and pull straight out. To replace the dairy bin, slide it into place and push down until it stops. NOTE: The dairy bin will only fit in the top space on the right-hand door. To remove the glass 1. [. . . ] Refer to the Understanding Sounds You May Hear section on page 32. THE ICEMAKER IS NOT PRODUCING ICE OR ICE CUBES ARE FREEZING TOO SLOWLY Check if. . . The freezer temperature is cold enough to produce ice. Wait 24 hours after hook-up for ice production. See the Setting the Controls section on page 16. [. . . ]