User manual LG M-G1010I

[. . . ] 12 Max current is measured according to IEC standard for safety and current is measured according to ISO standard for energy efficiency. CA U T I O N The manufacturer does not assume responsibility for accidents or injury caused by an incorrectly installed air conditioner. If you are unsure about installation, contact an installation specialist. E-2 Getting Started You have just purchased a Samsung window-type room air conditioner which should be installed following your installation manual. Your Owner's Instructions contain much valuable information on using your air conditioner. Please take the time to read them as they will help you take full advantage of the unit's features. [. . . ] Result: Each time you press the buttons: - The temperature is adjusted by 1°C - The unit beeps The air conditioner starts cooling, if the room temperature is higher than the selected temperature. If the room temperature reaches the set temperature, the air conditioner stops cooling, but the fan is still operating. Energy Saving Set/Cancel Mode C Mode Timer 4 Select the Fan Speed by pressing the button one or more times until the required setting is displayed: Low Medium High Result: Each time you press the button, the unit beeps. C Set/Cancel Energy Saving Timer Set/Cancel Energy Saving 5 T control the direction of the air flow, refer to page 23 and 24. o E-17 Airing Your Room Mode C Timer Set/Cancel If the atmosphere in your room is stale, you can air the room using the Fan feature. 1 If necessary, press the Result: (On/Off) button. Energy Saving The air conditioner starts up in the Cool mode. The unit beeps. 2 If the is not displayed at the top of the remote control, press the button on the remote control one or more times until it appears. Result: The unit beeps each time you press the The air conditioner runs in the Fan mode. button. Mode 24 C Timer Set/Cancel Mode Energy Saving 3 Select the Fan Speed by pressing the until the required setting is displayed: Low Medium High Result: Each time you press the button one or more times button, the unit beeps. Timer Set/Cancel Energy Saving 4 T control the direction of the air flow, refer to page 23 and 24. o E-18 Removing Excess Humidity Mode C If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much. 1 If necessary, press the Result: (On/Off) button. Timer Set/Cancel The air conditioner starts up in the Cool mode. The unit beeps. Energy Saving The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: Plugged in Stopped It will start up normally after three minutes. 2 If the is not displayed at the top of the remote control, press the button on the remote control one or more times until it appears. The unit beeps each time you press the The air conditioner runs in the Dry mode. Outdoor T emperature 21°C to 54°C approx. Indoor Humidity 80% or less If the air conditioner is used at. . . Higher temperature Lower temperature Higher humidity levels Water may condense on and drip from the surface of the unit if it is used for long periods. * for AW24XSHEB model only. E-25 Cleaning Your Air Conditioner Be sure to clean the air filter periodically to maintain the air conditioner in the best condition for a long period of time. When cleaning the air conditioner, turn it off and pull out the power plug. 1 Hold the air filter handle, slightly pull it to the left side and open the front grill. The removal of the front grill makes it easier to clean the air conditioner. CA U T I O N Front grill Air filter Removal and Reassembly of the Front Grill For user's safety, clip has been installed in the front grill. 1 Grasp the lower part of the front grill and the air filter handle, then open the grill. (The open angle of front grill has not to be exceeded 90 degree) 2 Pull out the front grill and remove it from front panel. 3 Reassembling of front grill should be done in reverse order of disassembly. 2 Front grill Grille groove Body guide Pull the air filter to the right side. Remove all dust on the air filter with a vacuum cleaner or brush. When you have finished, insert the air filter back into its original position. [. . . ] Check that the correct operating mode has been selected(Cool). Dust may be blocking the air filter; refer to page 26 for cleaning instructions. Check that there is no obstacle blocking the air flow into or out of the unit. In the case of an area where the drain pan can not be directly installed on the rear side of the unit after installing the air conditioner . [. . . ]