User manual LG MA1011W

[. . . ] The user could lose the authority to operate this equipment if an unauthorized change or modification is made. REGULATORY INFORMATION: FCC Part 15 This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] This product is manufactured to comply with the radio interference requirements of EEC DIRECTIVE 004/108/EC and 006/95/EC. 3 Important Safety Instructions 1. - All these safety and operating instructions should be read before the product is operated. - The safety, operating and use instructions should be retained for future reference. - All warnings on the product and in the operating instructions should be adhered to. - All operating and use instructions should be followed. - For example: near a bath tub, wash bowl, kitchen sink, laundry tub, in a wet basement; near a swimming pool; etc. - Unplug this product from the wall outlet before cleaning. Install in accordance with the manufacturer's instructions. - Slots and openings in the cabinet are provided for ventilation, to ensure reliable operation of the product, and to protect it from over- heating. The openings should never be blocked by placing the product on a bed, sofa, rug or other similar surface. This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided and the manufacturer's instructions have been adhered to. Tighten the M4 Tapping Screws after adjustment. Adjust the Tilt(Up /Down) by moving the Tilt Base then tighten Tilting Lock Screw. Set the Zoom Lever to a point between "Tele" and "Wide" to choose the desired angular field of view. Set the Focus Lever to a point between "Near" and "Far" to choose the desired focus of view. Install the Dome Cover to the main body by turning it counterclockwise to the end. Hole for Fixing Notes · · When you install the camera, handle with care. The camera could be damaged by improper handling or storage. If this camera is mounted on the other places except ceiling, you need an extra bracket for mounting. (not supplied) 9 Installation Camera Connection Connect the Power Adapter (1V, 300mA; optional) to the Power Input Jack of the camera as shown below. Power Input Jack Adapter Jack Power Adapter (Not supplied) BNC Monitor 10 Installation NOTES: · When you disassemble the Dome Cover, lift the Dome Cover Separatory Spring on the opposite side of LG Logo and turn the Dome Cover clockwise simultaneously. Dome Cover Separatory Spring · · When you install the camera, handle with care. The camera could be damaged by improper handling or storage. If this camera is mounted on the other places except ceiling, you need an extra bracket for mounting. (not supplied) 11 Setup 6-pin Dip Switch Setting This camera has the 6-pin Dip Switch for setting. AWB/HOLD AWB (Auto White Balance), HOLD (White Balance Hold). [. . . ] AGC (Auto Gain Control) If the image are too dark, change the maximum value to make the image lighter. The D&N function is activated automatically AGC ON mode. The default setting is ON. Troubleshooting Check the following guide for the possible cause of a problem before contacting service. The picture is poor Does the Dome Cover have lots of dust on the surface? [. . . ]