User manual LG MC-8083DR

[. . . ] Before installation, check the appliance for transportation damage. The appliance must be disconnected from the power supply during all installation work. Preparing the kitchen units Safe use of this appliance can only be guaranteed if it has been installed professionally in accordance with these installation instructions. [. . . ] Preparing the kitchen units Safe use of this appliance can only be guaranteed if it has been installed professionally in accordance with these installation instructions. The installer is liable for damages incurred as a result of incorrect installation. Units into which ovens are to be fitted must be heat-resistant up to 90 °C and adjacent cabinets up to 70 °C. Carry out all cut-out work on the furniture unit and worktop before fitting the appliances. Otherwise, the correct operation of electrical components may be adversely affected. Parts that are accessible during installation may have sharp edges. Wear protective gloves to prevent injury from cuts. If the plug is no longer accessible following installation, an allpole isolating switch must be present on the installation side with a contact gap of at least 3 mm. Contact protection must be ensured by the method of installation. Do not kink or trap the power cable, Fissaggio dell'apparecchio - Figura 4 1. There must be an air gap of 5 mm between the appliance and adjacent cabinets. Using a spirit level, adjust the appliance so that it is perfectly level. Disconnect the appliance from the power supply. Lift the appliance slightly and pull it out completely. [. . . ] Disconnect the appliance from the power supply. Lift the appliance slightly and pull it out completely. Sollevare leggermente l'apparecchio ed estrarlo A faulty power cable must only be replaced by a special replacement power cable from the manufacturer or from aftersales service. [. . . ]