User manual LG MG-6045W

[. . . ] Adjusting the Air Flow Direction Vertically . Adjusting the Air Flow Direction Horizontally . . Cooling Your Room Selecting the Automatic Operating Mode PROGRAMMING YOUR AIR CONDITIONER Setting the On Timer . Setting the Sleep Timer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . RECOMMENDATIONS FOR USE Operating Recommendations Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The air conditioner starts up in the mode selected when the unit was last used. The indoor unit beeps. 2 If the is not displayed at the top of the remote control, press the button on the remote control one or more times until it appears. Result: The indoor unit beeps each time you press the The air conditioner runs in FAN mode. button. Note 3 Select the fan speed by pressing the the required setting is displayed: Low Medium High Result: Each time you press the button one or more times until button, the indoor unit beeps. 4 To control the direction of the air flow, refer to pages 18 and 19. E-17 Adjusting the Air Flow Direction Vertically Depending on the position of the indoor unit on the wall of your room, you can adjust the position of the outer air flow blade on the bottom of the unit, thus increasing the efficiency of the air conditioner. 1 Press the Result: button one or more times as required. Cooling Heating Adjust the blade to face. . . Downwards. RECOMMENDATION 2 If you want the blade to move up and down automatically when the air conditioner is operating, press the button. Result: The blade moves up and down, around the base position set. 3 To stop the blade moving up and down, press the Note button again. If you switch the air conditioner. . . Set to the initial position powered. E-18 Adjusting the Air Flow Direction Horizontally ENGLISH There are two sets of inner air flow blades. Just as the outer air flow blade can be adjusted vertically, the inner blades can be adjusted horizontally. 1 Adjust each set of inner blades to the required position, by pushing or pulling them sideways. E-19 Setting the On Timer The On Timer enables you to switch on the air conditioner automatically after a given period of time. You can set the period of time from 30 minutes to 24 hours. 1 To set the operating time, press the button one or more times until the required time is displayed. Possible time is between 0. 5 hour and 24 hours inclusive. 2 Press the Result: (Set/Cancel) button to complete the setting. If necessary, set the air conditioner on before you wish to use the room. When outside temperatures are low and humidity is high, frost may form in the outdoor unit when heating is selected. If this happens: The heating operation is stopped. The Defrost mode is triggered automatically for about 10 minutes. The steam produced on the outdoor unit in the defrost mode is safe. No intervention is required from you; after about 10 minutes, the air conditioner starts operating again normally. Warm air circulation Frost & Defrost High indoor and outdoor If both the indoor and outdoor temperatures are high and you select the Heat mode, the outdoor unit's fan and compressor may stop at times. This is normal; simply wait until the air conditioner switches on again. If a power failure occurs when the air conditioner is operating, the unit is switched off. When the power returns, the air conditioner starts up again automatically. Power failure E-23 Temperature and Humidity Ranges The following table indicates the temperature and humidity ranges within which the air conditioner can be used. High temperatures Low temperatures High humidity levels Mode Heating Cooling Drying The automatic protection feature may be triggered and the air conditioner stopped. A water leak or some other malfunction may occur if the heat exchanger freezes. [. . . ] Check if the air conditioner is cooling only model. Check if the remote control is for cooling only model. Check if set temperature higher(lower) than current temperature. Select the Cool, Heat, Auto or Dry mode. [. . . ]