User manual LG MTP 4006

[. . . ] Do not share the same power outlet with other equipment to prevent overheating and fire. Do not operate with wet hands to prevent electric shock. If the supply cord is damage, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. it is strongly recommended to be installed with Earth Leakage Circuit Breaker (ELCB) or Residual Current Device (RCD) to prevent electric shock or fire. [. . . ] After waxing, aerate the room properly before operating the unit. Do not install the unit in oily and smoky areas. ensure drainage pipe is connected properly. After long period of use, make sure the installation rack is not deteriorate to prevent the unit from falling down. Remove the batteries if the unit is not going to be used for a long period of time. New batteries of the same type must be inserted following the polarity stated to prevent malfunction of the remote control. For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. Please be aware of the OFF indication on the remote control display to prevent the unit from starting/stopping improperly. Operating the unit within the recommended temperature could induce energy saving. The power indicator blinks during this operation. Use curtains to screen off sunlight and outdoor heat to reduce power consumption during cool mode. Press and hold 4 until you hear three beeps, then release. Raise and pull to remove the front panel. Press down both ends of the front panel to close it securely. Dry the filters thoroughly under the shade, away from fire or direct sunlight. Indoor fan stops occasionally during automatic fan speed setting. Airflow continues even after operation has stopped. Operation is delayed a few minutes after restart. Indoor fan stops occasionally during heating operation. Power indicator blinks before the unit is switched on. This may be due to damp smell emitted by the wall, carpet, furniture or clothing. Extraction of remaining heat from the indoor unit (maximum 30 seconds). [. . . ] När Timern är satt i läget ON, kan enheten starta tidigare (upp till 35 minuter) före den faktiska inställda tiden för att kunna nå den önskade temperaturen till den inställda tiden. These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste. For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC. By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. [. . . ]