User manual LG MV-1501B

[. . . ] Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the CAUTION instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. REGULATORY INFORMATION: FCC Part 15 This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] Insert the plug of this power cord into a wall outlet. Adjust the picture on the monitor using the Brightness and Contrast controls etc. 2. 2 11 Mounting the Lens 1. Remove the lens mount cap from the camera. CS mount type lens Carefully align the lens mount with the camera opening, then turn the lens slowly to install it. C mount type lens To allow for flange- back adjustment, install the C-mount adaptor (option) on the lens mount, then carefully align the lens mount with the camera opening and turn the lens slowly to install it. Connect the lens plug to the lens iris output connector (LENS) on the side of the camera. When using lenses from other makers, the plug shape may not correspond to the terminal on the camera. In such a case, remove the original plug and using a soldering iron, connect a lens iris plug according to the diagram. (Refer to next page. ) 1 2-2 2-1 1 3 Mounting the Lens Pin layout for the lens iris output connector Rewire the lens iris plug 1. Cut off the plug of the lens cable, cut off approximately 8mm of the insulation, and then strip approximately mm of the ends of the cable sheaths. 8mm 2mm No. 1 4 DC type lenses Damping Damping + Drive + Drive - VIDEO type lenses Vcc (+9V) Not used Video Ground . Solder the ends of the cable wires to the ends of the pins, and then attach the cover of the lens iris plug. 1 Concerning Auto-Iris Lenses DC type auto-iris lens A lens without driver circuit that operates only on a DC power source. Use To setting the [AUTO] function, select the [AUTO] on the [SHUTTER]. or button to set the SENS-UP limit . Note: If you set to one of the SHUTTER options except AUTO on the [SHUTTER] menu, the [SENS-UP] setting is not available and [---] mark is displayed. 5 White Balance Settings Setting the WB (White Balance) Mode You can select one of three modes for white balance adjustment. or button to select one of three modes for white Use balance then press . · ATW (Auto-Tracing White Balance): The color temperature range for the proper white balance is approximately 1700 11000K. Proper white balance may not be obtained under the following conditions: 1) ) ) · The color temperature is out of the 1700 - 11000K range. When the scene contains mostly high color temperature objects, such as a blue sky or sunset. When the scene is dim. AWCbPUSH: If you select the AWCbPUSH mode, you will be able to set up the White Balance automatically using button. 6 White Balance Settings · MANUAL: You can set the white balance options manually. COLOR TEMP: Use (INDOOR: 00, OUTDOOR: 5100) RED: Obtains the optimum amount of red gain. BLUE: Obtains the optimum amount of blue gain. It is a function of a color camera to delete the filter with the IR Cut function in an illumination below the standard value so that it has a better sensitivity. 7 Day/Night Setting 1. Use · or button to select mode for day/night function. [. . . ] Use · · or button to change a color effect. ON: Color screen OFF: B/W (Black and White) screen Setting the SYNC (Synchronization) You can select internal sync (INT) mode or line-lock (LINE) mode. The SYNC function is available only with AC power source. Select [SYNC] option on the [SPECIAL] menu. [. . . ]