User manual LG MV1604SW

[. . . ] This number is unique to this unit and not available to others. You should record requested information here and retain this guide as a permanent record of your purchase. ______________________________ Serial No. ______________________________ Date of Purchase_________________________ Disposal of your old appliance 1. [. . . ] While tape is playing press CM SKIP on the remote control to skip commercial (or another programme material). Repeatedly press CM SKIP to skip: 1 Press 30 seconds 2 Press 60 seconds 3 Press 90 seconds 4 Press 120 seconds 5 Press 150 seconds 6 Press 180 seconds OPR (Optimum Picture Response) This feature automatically improves playback picture quality by adjusting your DVD/VCR Combi receiver to the condition of the tape. Press OK. REC PSET SOFT R OFF 12 Pr-12 VCR ACMS TIME DATE NIC SYSTEM Dr. OPR f OSDSHARP ON 16:9 OPR OFF 4:3 i 4. Press 3 or 4 repeatedly to select: OFF, SOFT or SHARP. Please note you may only set OPR when playing a tape. Press i return to screen. 27 Operation Instant Timer Recording (ITR) Your DVD/VCR Combi receiver allows you to make recordings using a variety of simple methods: Instant Timer Recording (ITR) start recording immediately for a set period of time or until the video cassette runs out. Your DVD/VCR Combi receiver incorporates Long Play (LP) which enables you to record up to twice the amount of time on a video cassette. For example an E180 will record up to 180 minutes using Standard Play (SP); using LP you will be able to record up to 360 minutes. Please note there will be a slight loss in picture and sound quality when using LP. 5. Press SPEED if you wish to record in Long Play or Standard Play. SP will produce improved picture and sound quality, however LP will provide twice as much recording time as SP. If all timer record events are full press 3 or 4 to select the event that you wish to remove and replace. Press 1 to delete the event. PR -------DATE -------TIME - : - - ~ - -: - : - - ~ - -: - : - -~- - : - : - -~- - : - : - -~- - : - : - -~- - : - : - -~- - : SP SP SP SP SP SP SP i 6. Press the numbered buttons to enter the recording start and end times of the programme that you wish to record. Please note your DVD/VCR Combi receiver uses a 24 hour clock. You may also select the the start and end times by pressing 3 or 4. PR PR-01 ------DATE TIME 16 19 : 00 ~ 20: 00 -- - : - - ~ - -: - -- - : - -~- - : - -- - : - -~- - : - -- - : - -~- - : - -- - : - -~- - : - -- - : - -~- - : - - SP SP SP SP SP SP SP i 7. Press 3 or 4 to select the desired tape speed (SP, IP, or LP). IP mode determines how much tape is left and switches speed from SP to LP, if necessary, to complete recording the program. IP mode is not selected when VPS is ON. SP SP SP SP SP SP SP i 4. Press the numbered buttons to enter the station that you wish to record. When selecting stations 1 - 9, press 0 first, then the channel number; for example Stations 3 - 03. You may also select Channels by pressing 3 or 4. [. . . ] The batteries in the remote control are exhausted. This remote control uses the same buttons for VCR and DVD functions (ex. PLAY). Correction Point the remote control at the remote sensor of the DVD/VCR Combi receiver. Operate the remote control within 23 ft (7 m). [. . . ]