User manual LG NS-DVDVCR

[. . . ] REGULATORY INFORMATION: FCC Part 15 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] When this choice is made, this unit automatically converts any 96 kHz signals to 48 kHz so your system can decode them. If your receiver or amplifier is capable of handling 96 kHz signals, select 96 kHz. Check the documentation for your amplifier to verify its capabilities. Dynamic Range Control (DRC) With the DVD format, you can hear a program's soundtrack in the most accurate and realistic presentation. However, you may wish to compress the dynamic range of the audio output (the difference between the loudest sounds and the quietest ones). This allows you to listen to a movie at a lower volume without losing clarity of sound. Vocal Set to On only when a multi-channel karaoke DVD is playing. The karaoke channels on the disc mix into normal stereo sound. 16 Area Code Enter the code of the area whose standards were used to rate the DVD video disc, based on the list on page 28. Select "Area Code" on the LOCK menu then press B. Follow step 2 as shown previous page (Rating). Select the first character using v / V buttons. The tape is played at a speed 1/19 times slower than the normal speed. Use v/V (TRK) on the Remote Control if necessary to adjust the tracking. To return to the normal speed, press H (PLAY). Notes: · During slow motion, audio is muted and horizontal lines (noise bars) may appear on the TV screen. After 3 minutes in SLOW MOTION mode the unit goes back to PLAY mode to protect the tape and video heads. External Timer Recording If the external device that is connected to this unit has the timer reservation function, this unit can record the input signal the external device via the timer LINE1 jack. Connect the LINE1 input jacks on this unit to the AUDIO/VIDEO OUTPUT jack on the external device using the audio/video cables. Set the timer reservation setting of the external device. Insert a video cassette with the safety tab intact to this unit. Press z (REC) for more than 3 seconds on the front panel when the unit power is off. The " " mark will flashes on the display window. This unit is set to standby mode for the external timer recording. [. . . ] Unit SOURCE SELECT is not set to LINE1 or LINE2. 30 Specifications General Power requirements Power consumption Dimensions (approx. ) Net Weight (approx. ) Operating temperature Operating humidity Signal system Inputs VHS VIDEO IN(LINE1, 2) VHS AUDIO IN(LINE1, 2) Outputs VIDEO OUT S-VIDEO OUT COMPONENT VIDEO OUT (PROGRESSIVE SCAN) Audio output (digital audio) Audio output (analog audio) VCR Specifications Head system Timer Tape speed Tape width Maximum recording time Rewind time Frequency range Signal-to-noise ratio Dynamic range Channel separation DVD Specifications Laser system Frequency response Semiconductor laser, wavelength 650 nm DVD (PCM 96 kHz): 8 Hz to 44 kHz, DVD (PCM 48 kHz): 8 Hz to 22 kHz CD: 8 Hz to 20 kHz More than 90 dB (ANALOG OUT jacks only) Less than 0. 02% More than 95 dB (DVD/CD) Four head helical scan azimuth system 12-hour display type with AM, PM SP: 33. 35 mm/sec, LP: 16. 67 mm/sec, SLP: 11. 12 mm/sec 12. 7 mm SP: 2 HOURS (T-120), SLP: 6 HOURS (T-120)/8 HOURS (T-160) About 3 minutes (T-120) 20 Hz to 20 kHz More than 43 dB More than 88 dB More than 60 dB 1 V (p-p) 75 ohms, sync negative (Y) 1. 0 V (p-p), 75 ohms, negative sync, Mini DIN 4-pin x 1 (C) 0. 286 V (p-p) 75 ohms (Y) 1. 0 V (p-p), 75 ohms, negative sync, RCA jack x 1 (Pb)/(Pr) 0. 7 V (p-p), 75 ohms, RCA jack x 2 0. 5 V (p-p), 75 ohms, RCA jack x 1 2. 0 Vrms (1 KHz, 0 dB), 600 ohms, RCA jack (L, R) x 2 1 V (p-p) 75 ohms, sync negative, RCA jack x 2 -6. 0 dBm more than 47 ohms, RCA jack (L, R) x 2 120V, 60 Hz 16 W 16. 9" X 3. 1" X 10. 2" (430 X 79 X 260 mm) (w x h x d) 8. 8 lbs (4. 0 kg) 5°C to 40°C (41°F to 104°F) 5 % to 90 % NTSC Signal-to-noise ratio Harmonic distortion Dynamic range Accessories: Video cable x 1, Audio cable (L/R) x 1, Remote control x 1, Batteries (R03/AAA) x 2 Note : Design and specifications are subject to change without prior notice. 31 Reference ZENITH LIMITED WARRANTY-USA Zenith will repair or replace your product, at Zenith's option, if it proves to be defective in material or workmanship under normal use, during the warranty period ("Warranty Period") listed below, effective from the date ("Date of Installation") of original consumer purchase of the product. This warranty is good only to the original purchaser of the product and effective only when used in the United States, excluding U. S. WARRANTY PERIOD: LABOR: 90 DAYS from the Date of Purchase. PARTS: ONE YEAR from the Date of Purchase. [. . . ]