User manual LG PG60G

[. . . ] Owner's Manual DLP PROJECTOR Please read this manual carefully before operating your projector and retain it for future reference. For more information about licenses, visit www. €Dolby “and the double-D symbol are trademarks of Dolby Laboratories. This is an official DivX Certified® device that plays DivX video. [. . . ] 8 feet) (left/right) and within a 30 degree arc of the IR receiver. For yy seamless operation, do not block the IR receiver. When you carry the remote control in the portable bag, make sure that the buttons yy on the remote control are not pressed by the projector, cables, documents or any other accessories in the bag. Otherwise, it may significantly reduce the battery life. A/V IN HDMI/DVI RGB IN ꕯ ꕣ USING THE PROJECTOR 21 USING THE PROJECTOR Watching the Projector Turning on the Projector Watching the Projector ENGLISH 1 In Standby mode, press the POWER 2 Press the INPUT button and select 3 Control the projector using the folButton VOL -, + MUTE Q. 2 After waiting for a moment, press 3 In the Language Selection screen, select a language. The POWER button on the remote control or the control panel. (The light on the control panel will be turned on. ) 4 Select an input signal by using the Focus and Position of the Screen Image INPUT button on the remote control. 4 To turn the projector off, press the POWER button. When an image appears on the screen, check if it is in focus and fits the screen properly. Focus ring A/V IN HDMI/DVI RGB IN To yy adjust the focus of the image, rotate the focus ring. To yy adjust the focus ring, be careful not to touch the keys on the control panel. 22 USING THE PROJECTOR Using the battery Low battery!The projector will turn off soon * It is displayed when the battery is running out. * As your bettery is low, the projector will be turned off in a minute.  Battery using time information Status Charging Standard Usage Hours Time and Display About 3 hours About 2 hour (Available battery using time approximately 1 hour 30 mins when Energy Saving mode set to Max) Step 1 Step 2 Step 3 Step 4 Battery Level Indicator * f you do not use the projector for long periods of time, remove the battery from the I projector and store it separately. It is recommended to charge the battery to 40 - 50 percent for long-term storage. *  he battery is automatically recharged when the projector is connected to a power T supply. * Charge the battery fully when you first use the projector. *  he battery standard usage time given in the manual is based on measurements T taken by LG; the actual time may vary depending on usage. *  attery usage time may vary depending on broadcast type, operating temperature, B period of use, and user preferences. [. . . ] Mobile phone NOTE yy Connect the mobile phone to the HDMI IN port to view the phone screen on the Projector. Yy The MHL passive cable is needed to connect the Projector and a mobile phone. Yy This only works for the MHLenabled phone. 94 60 1920 x 1080 If yy an invalid signal is input into the projector, it will not be displayed properly on the screen or a message such as No Signal or Invalid Mode will be displayed. [. . . ]