User manual LG PQRCFCS0

[. . . ] It may cause fire or an electric shock. Do not place a heavy thing on the product. It may cause product breakdown. If the product was submerged under water, ask the service center for instruction. [. . . ] If the wired remote controller is changed before switching off the main power, the option function of the indoor unit can't be used. (option function like "slo" fan speed selection) Owner’s & Installation Manual 7 LO2K CN-REMO J15 • The product is being shipped with the cable connected only to the remote controller. Fix the connecting cable with the cable rack. LO1D C07D 2 Plug the connecting cable into the indoor unit. Main indoor unit LO1K Necessary functions before using Necessary functions before using Trial Operation The trial operation is to check the installation status of the product. The temperature will not be controlled during trial operation. Instead the product will operate in several modes such as cooling, strong wind, comp-on. 1 PQRCFCS0 If you want to set the trial operation mode, press the Room Temperature button and the fan speed button same time for three seconds. Defrost Preheat Out door Room Temp Total on Central Run 2 ROOM TEMP FAN SPEED Then the product will begin the trial operation and the display will be like as shown on left side picture. 3 4 If you want to cancel the trial operation mode, just press the On/Off button. The trail operation will shut down automatically after 18 minutes and system will go to the standby mode. * This function might not be available for Multi Product like Multi V system. 8 Simple Wired Remote Controller Necessary functions before using Setting the Central-Control Address Please set the address while using the central controller. You don't need to set address if you don't use central controller. ENGLISH 1 PQRCFCS0 If you want to set the address on the display panle, press both temperature control buttons (▲/▼) same time for three seconds. Defrost Preheat Out door Room Temp Total on Central Run 2 3 Press the temperature-increasing button to change the group number. Press the temperature-decreasing button to change the indoor unit number. As shown on the left side panel, it displays 23. : 3 Set the address by pressing both temperature control buttons again (▲/▼) same time for three seconds. ROOM TEMP FAN SPEED Group No. MODE FAN SPEED Indoor Unit No. • If you connect the indoor unit to the central controller, you should set the network address of the indoor unit so that the central controller could recognize it. • The center-control address is composed of the group number and the indoor-unit number. ❈ If you set the control status of the group, that you canʼt the central control and wireless remote control. Ownerʼs & Installation Manual 9 Necessary functions before using ESP Function E. S. P function is setting the volume of each fan speed. It is for the convenience of installation. It is recommended that you should not use this function while using the remote controller. 1 PQRCFCS0 Press the room temperature button and temperature incrreasing button L same time for three seconds Defrost Preheat Out door Room Temp Total on Central Run 2 3 Set the volume of each fan speed(Low, Medium, Hi) by using the temperature control button. Press the fan speed button to select the fan speed. [. . . ] When the fan operation is selected, "Fn" will be displayed on the display panel. Defrost Preheat Out door Room Temp Total on Central Run 2 3 ROOM TEMP FAN SPEED • Fan operation does not give cold air, but just the fan air. • By giving out air that has no difference of temperature with the indoors, it allows circulation of the room. * Temperature control is not available in the fan operation. 14 Simple Wired Remote Controller How to use the Mode Selection Button Fan Speed Selection ENGLISH You can easily control the fan speed. 1 Select the proper fan speed which you want by pressing the fan speed button on the remote controller. [. . . ]