User manual LG PTED0701DCA

[. . . ] If any substance is placed on it then balance may be destroyed so that the substance would drop down and cause a breakage or damage. Also the matter may cause trouble owing to which the grill would not be correctly inserted at front panel. · Don't shake suction grill. Or else there is worry that it may collide with adjacent material and the suction grill fall down. [. . . ] Or else there is worry that lift grill drive part is damaged and suction grill might drop down. · Don't place obstacle in lift passage of lift grill. When suction grill descends, it automatically stops at a certain distance. If there is any obstacle in lift passage, suction grill might drop down and there may be caused trouble failure of lift grill drive part. · Turn off the air conditioner operation button before operating the lift grill. Always stop the air conditioner operation for safety when suction grill descends. · Don't damage lift rope by a sharp material. Or else there is worry about suction grill dropping because of rope cutoff. How to Operate Elevation grille · Always stop the air conditioner operation for safety before operating lift grill. · Take heed _ there is worry about dust fall etc. · In case when the set automatic stop distance goes wrong, check the set value of operation panel and confirm if there is neither obstacle nor mankind. · When you are not to remove obstacle, stop the operation before touching the obstacle. Floor detection function ­ When the grille hits an obstacle during the drop, this function will detect the height from the floor and lift and stop the grille at 100mm above the location where it hit the obstacle. Lift stop function ­ If the panel is tilted when the grille is lifted and inserted to the panel, it will drop again to reinsert to the panel. (Repeated up to 2 times. ) -3- In Case of Abnormal Condition of Machine Symptom Suction grill does not move even if I operate Remote Controller. It does not operate though it moves a little. Please first check the following before asking our A/S. ENGLISH Remedy Restart the operation after electric power supply recovery. Remove the material. Cause Is it not electric power cutoff?Has electric cell been inserted in Remote Controller?(In case when suction grill has not been attached or only one side of wire has been attached, equipment operation automatically stops. ) Is there not any material inside?Has air filter been correctly installed?It is because there occurred a little aberration in winding of right and left wires. Correctly affix suction grill. Suction grill cannot be inserted. (It does not ascend. ) Suction grill is slant by 1~2 cm. (And it does not go down any more. ) Correctly install air filter after removing causative material if any. [. . . ] But it is not abnormal. Has it not been placed on a desk table ? (It automatically stops as wire is loosened. ) It is because suction grill has come down unto automatic stop position. There arises noise during ascension operation. There is sound for a few seconds after inserting the suction grill. But it is not abnormal. If you wish to change automatic stop position, consult with your sale agency. [. . . ]