User manual LG PTED1202WCA

[. . . ] Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. REGULATORY INFORMATION: FCC Part 15 This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] · Provider:DisplaystheDDNSprovider. IP list > Basicpolicy:Selectthebasicpolicytype. Allowall:AllowalltheIPaddressbasically, but the IP addresses in the list are denied. Denyall:DenyalltheIPaddressbasically, butthe IP addresses in the list are allowed. It needs at least one IP address to activate this function. Save:Clickthisbuttontoconfirmthesettings. · · IP filtering The access of the IP addresses in the list are allowed or denied according to the choice made in the drop-down list of the Basic policy option. The administrator can add up to 10 IP address entries to the list (a single entry can contain multiple IP addresses). The users from these IP addresses need to be specified in the user list with the appropriate access rights. The IP list is to control the access permission of clients by checking the client IP address. Save:Clickthisbuttontoconfirmthesettings. From:EnterthestartIPaddressfortheIPfiltering. To:EntertheendIPaddressfortheIPfiltering. Note: If you want to deny or to allow a range of IP addresses, enterthestartIPaddressto"From"andtheend IPaddressto"To". YoucanalsoaddanIPaddressby enteringtheIPaddressto"From"and"To". Operation and settings 33 3. Here a calendar is provided to mark the event detection activity. SettheActivationTimeparameters(24hclock)for the event. NONE:Noscheduledrecording CONTINUITY:Recordingstartsautomaticallyfrom the preset time. VA:Recordingstartsautomaticallywhenthe object or event is detected within a designated time. SENSOR:Recordingstartsautomaticallywhenthe sensor input of the IP device is activated within a designated time. DUPLICATED(C, V):Recordingstartsautomatically from the preset time. When the object or event has been detected within a designated time, change the continuous recording mode to VA event recording mode and recording starts automatically. DUPLICATED(C, S):Recordingstartsautomatically from the preset time. When the sensor input is activated within a designated time, change the continuous recording mode to the sensor event recording mode and recording starts automatically. DUPLICATED(V, S):Recordingstartsautomatically when the object or event is detected or the sensor input is activated within a designated time. - - To set the Recording Schedule 1. Recording schedule setting window is displayed. [. . . ] If we obtain lower frame rate than set we need to check from the system administrator for sufficient bandwidth available or reduce the 50 Reference number of applications running on the client computer. · · · If the client PC's are unable to access the multicast stream, check with the system administrator for the use of a valid multicast address or check if the router is supporting multicasting. If the images appear to have white of gray stripes on it, upgrade the Video graphics driver on the client PC to the latest version. Video images may be noisy if you are using the camera in a very low light environment or the bit rate/quality is set to very low values. [. . . ]