User manual LG R-6000A

[. . . ] · Do not use for other purposes such as preservation of food. · Do not use any combustible equipment in front of the airflow outlet. · Do not expose directly to cold air for a long period. · Ensure that the drainage pipe is connected properly. [. . . ] If you wish to discard this product, please contact your installer, dealer or local authority and ask for the correct method of disposal. · Do not switch ON the unit when waxing the floor. After waxing, aerate the room properly before operating the unit. · Do not install the unit in oily and smoky areas. 3 ENGLISH PRODUCT OVERVIEW & OPERATIONS PRODUCT OVERVIEW & OPERATIONS e-ion AIR PURIFYING SYSTEM Do not touch during operation e-ion filters Front panel Active e-ion Power Module Active e-ion Generator Auto OFF/ON button · Used when remote control is misplaced or malfunction. Press and hold until 1 beep is heard, then release. INDICATOR Mode Auto Cooling (Green) (Orange) (Orange) (Orange) (Blue) tan ce Airflow direction louver · Do not adjust by hand. um Receiver 8m s: TO TURN ON OR OFF THE UNIT · Please be aware of the OFF indication on the remote control display to prevent the unit from starting/stopping improperly. TO SET TEMPERATURE Ma xim dis Remote control display · For heat, cool and dry modes, the range of temperature for selection is 16°C ~ 30°C. · Operating the unit within the recommended temperature could induce energy saving. DRY mode : 1°C ~ 2°C lower than room temperature. TO SELECT OPERATION MODE AUTO mode - For your convenience · Unit selects the operation mode according to the room temperature. · Once auto mode is selected, the unit will operate at the standard setting temperature. · To change the standard setting temperature, press for "HI" or for "LO". Temperature setting of 1°C higher in cool mode or 2°C lower in heat mode than the desired temperature performs a 10% power saving. Use curtains to screen off sunlight and outdoor heat to reduce power consumption during cool mode. 5 · · and can be activated even when the unit is turned off. In this condition, fan speed and air swing can not be adjusted. ENGLISH TO SELECT FAN SPEED (3 OPTIONS) TO SET THE TIMER CARE & CLEANING CAUTION · Switch off the power supply and unplug before cleaning. · Do not touch the aluminium fin, sharp parts may cause injury. HINTS · Clean the filter regularly for best performance and to reduce power consumption. · Please consult your nearest dealer for seasonal inspection. WASHING INSTRUCTIONS · Do not use benzene, thinner or scouring powder. · Use only soap ( pH7) or neutral household detergent. · Do not use water hotter than 40°C. ALUMINIUM FIN FRONT PANEL Raise and pull to remove. Wash gently and dry. INDOOR UNIT Wipe the unit gently with a soft, dry cloth. Remove ACTIVE e-ion GENERATOR Clean with dry cotton bud. [. . . ] Inconsistent airflow during PATROL operation. · Fan speed is adjusted automatically during patrol operation. Select QUIET operation to maintain the airflow consistency. Check the following before calling for servicing. Symptom Heating/Cooling operation is not working efficiently. [. . . ]