User manual LG RM-27LZ50

[. . . ] The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. NOTE TO CABLE/TV INSTALLER: This reminder is provided to call the CATV system installer's attention to Article 820-40 of the National Electric Code (U. S. A. ). The code provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of the cable entry as practical. REGULATORY INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Press the ENTER button to save. D /E D /E button to select A VL. button to to select On or Off. Sound EZ Audio AVL Balance On Off D F E OK MENU 19 Operation Sound Menu Options continued Sound Balance 1. Press the MENU button and then use D / E button to select the Sound menu. 2. Press the G button and then use D /E /G button to select Balance. button to adjust the sound balance. 3. Press the G button and then use F Sound EZ Audio AVL Balance 0 · Balance is adjustable from Left 50 to Right 50. Press the ENTER button to save. D FG E OK MENU Stereo/SAP Broadcasts Setup - The TV can receive MTS stereo programs and any SAP (Secondary Audio Program) that accompanies the stereo program, if the broadcaster transmits an additional sound signal as well as the original one. - Mono: The primary language is heard from left and right speakers. - Stereo: The primary language is heard from left and right speakers. - SAP: The secondary language is heard from left and right speakers. 1. Press the MTS button repeatedly. Mono Stereo SAP · Select mono sound mode if the signal is not clear or in poor signal reception areas. Press the G OK MENU button and then use D /E button to select Run or Hold. · Hold: Off timer/On timer will not work. Press the ENTER button to save. Sleep Timer Setup - The Sleep Timer turns the TV off at a preset time. Press the SLEEP button repeatedly to select the number of minutes. First the Sleep --- option appears on the screen, followed by the following sleep timer options: 10, 20, 30, 60, 90, 120, 180, and 240 minutes. When the number of minutes you want is displayed on the screen, press the ENTER button. The timer begins to count down from the number of minutes selected. To check the remaining minutes before the TV turns off, press the SLEEP button once. To cancel the Sleep Timer, press the SLEEP button repeatedly until Sleep --- appears. Auto Off Off - If Auto Off is active and there is no input signal, the TV switches to Standby mode automatically after 10 minutes. Press the menu button and then use D / E button to select the Timer menu. Press the G G Timer Clock Off timer On timer Auto off button and then use button and then use D /E D /E button to select Auto off. Press the ENTER button to save. On Off D F E OK MENU 22 Operation Special Menu Options Closed Captions Closed captioning is a process which converts the audio portion of a television program into written words which then appear as subtitles on the television screen. [. . . ] · Check your antenna direction and/or location. · Test the wall power outlet, plug another product's power cord into the outlet where the product's power cord was plugged in. · This is normal, the image is muted during the product startup process. Please contact your service center, if the picture has not appeared after five minutes. [. . . ]