User manual LG S186DP

[. . . ] The room temperature sensor functions in either indoor unit or remote controller. · The sensor setting was made to the indoor unit side when the product was shipped. To change the setting to the remote controller side, push the sensor button (right figure) inside the remote controller cover and check that "Main sensor" disappears from the LCD display. Note: Even if the sensor is set to the remote controller side, when the room temperature data from the remote controller does not arrive at the indoor unit for 10 minutes, the sensor setting automatically changes to the indoor unit side. [. . . ] Set bit 1 of DIP switch S003 on the signal receiving part P. C. Attach the signal receiving part to the ceiling panel by reversing the procedure of removal, and then turn on the power of the air conditioner. Push [START/STOP] on the wireless remote controller, and select COOL or HEAT with [Mode select]. (Temperature cannot be controlled during a test run. ) 5. All LEDs on the signal receiving part flash during a test run. After the test run has been completed, be sure to set bit 1 of DIP switch S003 to OFF and confirm that the LEDs do not flash. Clamp the wires properly with the clamper secured together with the signal receiving part cover. Note 1: Use the forced test run only for test run because it overloads the air conditioner. Note 2: The remote controller is disabled for approx. 1 minute after power-on, but this is normal. The signal from the remote controller is received, but the receive data is discarded. Clamper Screw Signal receiving part cover DIP switch Signal receiving part P. C. Clamp the wires properly with the clamper secured together with the signal receiving part cover. - Power is not turned on. - Incorrect connection between signal T receiving part and indoor unit hese LEDs do not light or flash even if the remote controller is operated. Settings when installing the wireless remote controller kit together with wired remote controller A dual remote controller system is available by installing the wireless remote controller kit together with the wired remote controller. (Up to two wireless and wired remote controllers can be installed. ) The dual remote controller system controls one or more indoor units with two remote controllers. Note: Connect wires correctly to the signal receiving part, checking terminal numbers on the indoor unit. If Note: Note: 220/240 VAC is applied, the circuit will be broken. Multiple wireless remote controller kits cannot be attached to one indoor unit. To use the wireless remote controller kit together with the wired remote controller, set either remote controller to a follower remote controller. Remote controller address setting · When two or more signal receiving parts are installed in a room, a unique address can be set for each signal receiving part to prevent interference. · When you push the reset button after replacing batteries, the address displayed on the remote controller shows "ALL" While "ALL" is displayed, signals from the remote controller can be received regardless of the setting of the address switches in the signal receiving part. · For how to change remote controller addresses, refer to the Owner's Manual. · Detach the signal receiving part cover of the signal receiving part when changing the signal receiving part address. After the setting change has been completed, clamp the wires properly with the clamper secured together with the signal receiving part cover. Address displayed on the remote controller Address switch setting in the signal receiving part Address Address Address Address Flashing Loose connection between signal receiving part and indoor unit Check connections and reconnect wires correctly, if necessary. (Fig. [. . . ] · To use the wireless remote controller as a follower, set bit 3 of DIP switch S003 on the signal receiving part P. C. Controlling one indoor unit by two remote controllers · The indoor unit is operable regardless of the settings (Header or Follower) of the remote controllers. Wireless remote controller kit * (Header) (Separately sold) Signal receiving part Wired remote controller * (Follower) The protective device of the outdoor unit is activated. Flashing alternately Check the outdoor unit. * Any address setting is OK. The protective device of the indoor unit is activated. [. . . ]