User manual LG UB2HVAS01P

[. . . ] (If they are not fastened securely enough, the TV may tilt forward after being installed. ) Do not use too much force and over tighten the screws; otherwise screw may be damaged and not tighten correctly. Tidying cables Gather and bind the cables with the cable holder. (Only 19LS35**) NOTE yy Remove the stand before installing the TV on a wall mount by performing the stand attachment in reverse. [. . . ] It is recommended to mount the isolator to the wall. If it cannot be mounted to the wall, mount it on the TV. Avoid disconnecting the antenna Isolator after installation. -- Before starting, be sure that the TV antenna is connected. Connect one end of the isolator to cable/antenna jack and the other to TV set or set-top box. €Equipment connected to the protective earthing of the building installation through the mains connection or through other equipment with a connection to protective earthing - and to a cable distribution system using coaxial cable, may in some circumstances create a fire hazard. Connection to a cable distribution system has therefore to be provided through a device providing electrical isolation below a certain frequency range (galvanic isolator, see EN 60728-11)” W  hen applying the RF Isolator, a slight loss of signal sensitivity can occur. 14 ASSEMBLING AND PREPARING ENGLISH ENG CAUTION yy Power Cord Installation Guide -- If the power cord provided with TV looks like the below picture, please ensure that it is inserted in the right direction. TV Power Cord Correct Wrong ASSEMBLING AND PREPARING 15 Parts and buttons ENGLISH ENG A type : 19/22/26/32LS35**, 26/32/42CS46**, 32/42LS340* B type : 32/42LS345* Screen Screen buttons Remote control and intelligent sensors1 Power indicator Speakers OK OK Speakers Remote control and intelligent sensors1 SETTINGS INPUT Touch buttons SETTINGS INPUT OK SETTINGS INPUT Power indicator A type2 H H Buttons B type Adjusts the volume level. Accesses the main menu, or saves your input and exits the menus. 1 Intelligent sensor - Adjusts the image quality and brightness based on the surrounding environment. »» Personal injury may occur if hands or fingers are pinched. If the product is tilted too much, it may fall, causing damage or injury. 18 ASSEMBLING AND PREPARING Securing the TV to a wall (This feature is not available for all models. ) Using the Kensington security system (Depending on model) The Kensington security system connector is located at the rear of the TV. For more information of installation and using, refer to the manual provided with the Kensington security system or visit http://www. Connect the Kensington security system cable between the TV and a table. ENGLISH ENG 1 Insert and tighten the eye-bolts, or TV brackets and bolts on the back of the TV. -- If there are bolts inserted at the eye-bolts position, remove the bolts first. 2 Mount the wall brackets with the bolts to the wall. Match the location of the wall bracket and the eye-bolts on the rear of the TV. 3 Connect the eye-bolts and wall brackets tightly with a sturdy rope. [. . . ] English View the encrypted (pay) services in digital TV mode. This feature is not available in all countries. USB IN NOTE yy Check if the CI module is inserted into the PCMCIA card slot in the right direction. If the module is not inserted properly, this can cause damage to the TV and the PCMCIA card slot. [. . . ]