User manual LG UB5HVMS01P

[. . . ] ) Do not use too much force and over tighten the screws; otherwise screw may be damaged and not tighten correctly. Not using the Desk Type stand Only 32/42LM340*, 47CM96** 1 Push the supplied Protection cover into the opening at the bottom of the TV until clicking sound. NOTE Remove the stand before installing the TV on a wall mount by performing the stand attachment in reverse. Protection Cover A-6 SETTING UP THE TV Tidying cables Only 42/47/55LM615*, 32/42/47LM585* 1 Use Cable Management to neatly secure and position cables together 2 Fix the Cable Management firmly to the TV. [. . . ] Cinema 3D Glasses The number of 3D glasses may differ depending on the model or country. A-4) CAUTION yy Power Cord Installation Guide -- If the power cord provided with TV looks like the below picture, please ensure that it is inserted in the right direction. TV Power Cord Correct Wrong ASSEMBLING AND PREPARING 15 NOTE yy Antenna Isolator Installation Guide -- Use this to install TV in a place where there is a voltage difference between TV Set and GND of antenna signal. »» If there is a voltage difference between TV Set and GND of antenna signal, the antenna contact might be heated and excessive heat might cause an accident. -- You can improve the safety when watching TV by efficiently removing power voltage from TV antenna. It is recommended to mount the isolator to the wall. If it cannot be mounted to the wall, mount it on the TV. Avoid disconnecting the antenna Isolator after installation. -- Before starting, be sure that the TV antenna is connected. Connect one end of the isolator to cable/antenna jack and the other to TV set or set-top box. €Equipment connected to the protective earthing of the building installation through the mains connection or through other equipment with a connection to protective earthing - and to a cable distribution system using coaxial cable, may in some circumstances create a fire hazard. Make sure not to hold the transparent part, speaker, or speaker grill area. 10 cm 10 cm m 10 c 10 cm 2 Connect the power cord to a wall outlet. CAUTION yy Do not place the TV near or on sources of heat, as this may result in fire or other damage. 18 ASSEMBLING AND PREPARING Securing the TV to a table Fix the TV to a table to prevent from tilting forward, damage, and potential injury. (Only 32/37LM611*, 32/42/47LM580*, 32/42LM34**, 32/37/42/47LS56**) To secure the TV to a table, insert and tighten the supplied screw on the rear of the stand. Adjusting the angle of the TV to suit view (Only 32/37LM611*, 32/42/47LM580*, 32/42LM340*, 32/37/42/47LS56**, 47CM96**) Swivel 20 degrees to the left or right and adjust the angle of the TV to suit your view. ENGLISH ENG 20˚ 20˚ (Only 42/47/55LM615*, 32/42/47LM585*) Swivel 10 degrees to the left or right and adjust the angle of the TV to suit your view. (Only 32LM585*) 1 Connect the Desk-mount Cables to the Stand Base using the Bracket Screws. 2 Fix the Desk-mount Cables to a table using the Desk-mount Screws. 3 Once the TV is fixed, move the table close to the wall. 10˚ 10˚ CAUTION yy When adjusting the angle of the product, watch out for your fingers. [. . . ] Optical Digital Audio Out is not available yy when connecting a headphone. Yy When watching digital TV in 3D imaging mode, TV out signals cannot be output through the SCART cable. (Only 3D models) yy If you set the 3D mode to On while a scheduled recording is performed on digital TV, monitor out signals cannot be output through the SCART cable, and the recording cannot be performed. This feature is not available in all countries. [. . . ]