User manual LG V-2810DE

[. . . ] Do not allow the vacuum cleaner to run unattended at any time. Use the vacuum cleaner only for its intended use as described in these instructions. Do not use the vacuum cleaner without a dust bin. [. . . ] Do not use the vacuum cleaner without a dust bin. Empty the dust bin before it is full in order to maintain the best efficiency. Do not use the vacuum cleaner to pick up matches, live ashes or cigarette butts. Keep the vacuum cleaner away from stoves and other heat sources. Heat can deform and discolour the plastic parts of the unit. Avoid picking up hard, sharp objects with the vacuum cleaner as they may damage the cleaner parts. Do not block the suction or the exhaust port. Switch the vacuum cleaner off on the body of the machine before unplugging from the electrical outlet. Be cautious not to damage brush during unclogging. 5 3 EMPTYING THE DUST BIN 1 Option 2 3 Once dust reaches the dust full mark, or once the dust full light is on, empty the dust bin. Take the dust bin out by pressing the button. Separate the dust bin cover. CLICK 4 5 6 Throw away dust into the bin. Close the dust bin cover. Before use, push the dust bin into the main body of the vacuum cleaner until you hear the "click" sound. - Empty into a plastic bag (recommended for asthma/allergy sufferers) NOTE You may rinse the dust bin with cold water 6 4 CLEANING THE DUST PACK 4-1. WHEN TO CLEAN THE DUST PACK - If suction is noticeably reduced during cleaning, please check the dust pack as indicated below. Suction is significantly weakened during cleaning. Shaking sound of inlet stuck to the floor (soft mats, blankets, etc. ) is heard. Turn the vacuum power to 'MAX' HANDLE CONTROL If the filter check indicator turns red with the inlet floating 10 cm above flat floor, clean it. When the indicator light comes on, please empty the Dust Pack(4-2) as shown in the following illustrations. 7 4-2 CLEANING THE DUST PACK 1 2 3 Remove the dust bin and dust pack as shown. Remove the fixed frame of the dust pack cover. Remove the sponge and filter from the dust pack. 4 5 6 Wash the sponge and the filter of the dust pack with water. Let the sponge and filter dry in the shade for more than 12 hours. Put the sponge and filter into the dust pack. 7 8 Before reassembly, align the dust pack cover and dust pack correctly. Put the assembled dust pack into the main body. NOTE : Make sure the filter is completely dry before putting it back into the vacuum cleaner. Allow 12 hours for it to dry. 8 5 CLEANING THE MOTOR PROTECTION FILTER Take out both the dust bin and the dust pack. Remove the motor protection filter from the vacuum cleaner. Shake and tap the dust from it and put back in machine. 6 CLEANING THE OUTLET FILTER Press the fixed frame part at the back of the main body to remove. Pull out the HEPA Filter Dust the HEPA filter. using the tab. Put the HEPA filter into the main body until you hear a `click' sound. OPTION - MICRO CARBON FILTER NOTE : Replacement filters are available at your local Samsung distributor. Remove and replace the blocked outlet filter. 9 - IF YOU HAVE A PROBLEM PROBLEM Motor does not start. Nozzle, suction hose or tube is blocked. [. . . ] using the tab. Put the HEPA filter into the main body until you hear a `click' sound. OPTION - MICRO CARBON FILTER NOTE : Replacement filters are available at your local Samsung distributor. Remove and replace the blocked outlet filter. 9 - IF YOU HAVE A PROBLEM PROBLEM Motor does not start. Nozzle, suction hose or tube is blocked. [. . . ]