User manual LG V-C3920NDV

[. . . ] Keep hair, loose clothing, fingers and all parts of body away from openings and moving parts. Do not use to pick up anything that is burning or smoking, such as cigarettes, matches or hot ashes. Do not use without dust bag and filters in place. Turn off all controls before unplugging. [. . . ] Insert one screw provided from the screw packet into the existing hole. Tighten securely with a Philliphs head screwdriver. Step 2. Attaching the Hose and Tools 1-3 Position the Hose Assembly on the back of the vacuum as shown. Attach the Hose with the remaining two screws from the packet. Tighten securely with a screwdriver. 1-4 Slide the Grasping the Quick 1-5 Extension Reach Handle, slide the Wand and end of the Hose Wand the Crevice onto the Hose Wand Tool together Base. Snap the Hose into the into the Hose Clip. storage clip NOTE: The Powerfoot as shown. will not operate effectively unless the Hose Wand is firmly Slide the Dusting Brush Tool into the storage clip as shown. How to use you samsung vacuum 2-1 2-2 2-3 ON-OFF Switch 1. To turn cleaner ON(I), press the ON/OFF switch to the ON position. 2. To the cleaner OFF(O), press the ON/OFF switch to the OFF position. Handle positions The handle of your cleaner has three positions; upright for storage and when using cleaning tools; operating for general operation on carpet and floors; low for reaching under low furniture. Step on handle release pedal to lower handle. Transporting cleaner To move your cleaner from room to room, put the handle in upright position, tilt the cleaner back on its rear wheels and push forward. Dusting Brush Tool: Use to dust furniture, blinds, books, lamps, shelves, draperies, cushions. 2-4 2-5 A Crevice Tool: Use in tight narrow spaces. Extension Wand: B C Use with desired attachment for a longer reach. NOTICE: Carrying handle The cleaner can also be moved by using the carrying handle. The Floor Brush will continue to rotate while you use your vacuum Cleaning Tool attachments for above floor cleaning. Brush the dirt off the Louvers and Upper Tank Filter. 3-1 Unlock Position Full Line Lock Position 3-3 The foam Upper Tank Filter may be removed and hand washed in cold water with mild detergent. Rinse well then air dry thoroughly before replacing. The Upper Tank and Louvers may also be wiped clean with a damp cloth. Unplug the cleaner from electrical outlet. Slide the Lock `n Seal Lever to the "Unlock" position. Grasp handle and pull the Dirt Container straight out to remove from vacuum. Put the Dirt Container back in the vacuum and slide the lever to the "Lock" position. Note: The Dirt Container may be washed in warm water with a mild detergent. Make sure it is completely dry before using again. 4 Maintenance 3-4 Cleaning The Pre-Motor and Post-Motor Filters 3-5 Post-Motor Filter Pre-Motor Filter 3-6 How to replace Disconnect cleaner from electrical outlet. Place handle in low position and turn cleaner over so bottom side is up. Remove the 4 screws as shown with a screw driver. The Pre-Motor Filter protects the motor from dirt particles. It is located in the slide out tray underneath the Dirt Container. If the filter becomes dirty, pull out the tray, lift out the filter and clean. [. . . ] the belt into the rectangular slot (F) on side of cleaner. Pull other side of agitator (G) into place. 3-12 Turn agitator, making sure belt is not pinched between agitator and agitator shield. 3-14 Suction Inlet When to replace the agitator brush roll When agitator brushes are worn, the agitator should be replaced. To check condition of brushes, disconnect cleaner from electrical outlet. [. . . ]