User manual LG V-C60162ND

[. . . ] Read and follow all instructions before using your vacuum cleaner to prevent the risk of fire, electric shock, personal injury, or damage when using the vacuum cleaner. This guide do not cover all possible conditions that may occur. Always contact your service agent or manufacturer about problems that you do not understand. This appliance complies with the following EC Directives:-2006/95/EC Low Voltage Directive-2004/108/EC EMC Directive This is the safety alert symbol. [. . . ] If these conditions are found, fix them and wait at least 30 minutes before attempting to use the vacuum cleaner. After the 30 minute period, plug the vacuum cleaner back in and turn on the switch. Fit the large cleaning head into the end of the tube. Push telescopic tube into nozzle outlet. Release spring latch to lock the tube in position. Push telescopic tube into hose handle firmly. Push the end of the head on the flexible hose into the attachment point on the vacuum cleaner. To remove the flexible hose from the vacuum cleaner, press on the button situated on the head, then pull the head out of the vacuum cleaner. Suction power may be weakened when insignificant dusts are sucked. Make the dust box empty if dusts are filled to the maximum degree and then clean the filter when it becomes 5 times. How to Use Using the cleaning head and Accessory Nozzles àÒÔÓθÁÓ, ÌË ԰ÎÂÒÓÒ àÒÔÓθÁÓ, ÌË ÂÚÍË Ë ÓÔÓÎÌËÚÂθ̰i ÌÒÓÍ And then, fit the Dusting Brush, Crevice Tool and Upholstery Nozzle onto the accessory holder. Fit the accessory onto the end of the tube. Dusting Brush is for vacuuming picture frames, furniture frames, books and other irregular surfaces. Crevice Tool is for vacuuming in those normally hard-to-reach places such as reaching cobwebs, or between the cushions of a sofa. The 2 position cleaning head equipped with a pedal which allows you to alter its position according to the type of floor to be cleaned. Hard floor position (tiles, parquets floor) Press the pedal to lower brush. You can perform cleaning at any place like corner or crevice since revolution of the suction hole is free. Remove dusts accumulated where the floor surface of the suction hole for device protection is dirty. Cleaning of the whole suction hole with water may cause failure of product performance. Suction power may be weakened when insignificant dusts are sucked. [. . . ] The bottom part can be separated to be cleaned. Since the bottom does not stick to the surface, vacuuming is easy. How to use àÒÔÓθÁÓ, ÌË ԰ÎÂÒÓÒ Follow the directions below for proper use. Set the suction power control switch to MAX POWER before vacuuming. [. . . ]