User manual LG V-C6200HTV

[. . . ] The fumes from these substances can create a fire hazard or explosion. Doing so could result in death or personal injury. Do not use an extension cord with this vacuum cleaner Using improper voltage may result in damage to the motor and possible injury to the user. Proper voltage is listed on the bottom of vacuum cleaner. [. . . ] Doing so could result in death or electrical shock. Turn off all controls before unplugging. â· Do not change the plug in any way. Doing so could result in product damage or electrical shock. Keep hair, loose clothing, fingers, and all parts of the body away from openings and moving parts. Improper repairs may lead to serious hazards for the user. Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not plug in if control knob is not in OFF position. Keep children away and beware of obstructions when rewinding the cord to prevent personal injury Do not allow to be used as toy. Close attention is necessary when used by or near children. Do not use it if it is damaged, cut or punctured. check the vacuum cleaner for possible source of overheating such as a full dust tank , a blocked hose or clogged filter. If these conditions are found, fix them and wait at least 30 minutes before attempting to use the vacuum cleaner. After the 30 minute period, plug the vacuum cleaner back in and turn on the switch. Using the cleaning head and Accessory Nozzles Dusting Brush is for vacuuming picture frames, furniture frames, books and other irregular surfaces. Crevice Tool is for vacuuming In those normally hard-to-reach places such as reaching cobwebs, or between the cushions of a sofa. How to use The dust chamber needs emptying when the dust is full by MAX which is marked on the dust chamber. Your appliance is equipped with both the dust chamber and the motor filter. press the button and pull the dust chamber forward. Press the bottom plate lever and empty the dust chamber. â· To refit the dust chamber, push the dust chamber into the tank mount until it will go no further. How to use cleaning the dust chamber Wash both parts with soft material. [. . . ] Gently rinse both parts separately under a cold running tap until the water runs clear. The filter and the mesh need cleaning when the light is shining. â· Remove supporter filter case and clean the filter and case in cold water only. Let filter dry for 24 hours In the shade before putting it back. [. . . ]